Proxima ASA BNDL-001, PL-300E manual Troubleshooting Table, Symptom Solutions

Troubleshooting Table

Troubleshooting Table

SYMPTOM	SOLUTIONS
No power	Plug the transmitter and receiver power adapters
	into an AC outlet. Ensure the Computer 1 LED
	on the transmitter is solid green. Also make sure
	the UTP input LED on the receiver is either blink-
	ing or on.

All lights flash- ing twice per second (2hz)

This indicates the dip switches are set incorrectly or in an unsupported configuration. See “Appen- dix C: Dip-Switch Settings” on page 51 for rec- ommended dip switch settings.

Lights flashing	This indicates a firmware error or the projector
alternately	associated with your X350 installation does not
(back and	support the current version of the PL-300 hard-
forth)	ware. Please contact Technical Support to help
	resolve the problem.
No image	Ensure the UTP LEDs on both the transmitter and
	receiver are blinking green. This indicates the
	connection between the transmitter and receiver
	is intact.
	If the UTP LEDs are blinking green and there is a
	source connected to the transmitter, make sure
	that source is selected.
	If using a laptop computer, make sure that exter-
	nal video is enabled. See your computer’s User’s
	Guide for more information.
	Ensure the color controls on the receiver are not
	in the vertical position. If any of the three are in
	the vertical position, the image will not appear.
Image is fuzzy	Adjust the gain control on the side of the receiver.
or out of focus	Adjust the three color controls on the bottom of
	the receiver.

46 ProjectionLink User & Installation Guide