Proxima ASA BNDL-001, PL-300E manual Troubleshooting

	Troubleshooting
SYMPTOM	SOLUTIONS
Computer	Adjust the Clamp level in your projector. To do
Audio modu-	this select Menu, PC Adjust, Free Mode. In Free
lates the black	Mode select the ￿menu item. Select Clamp and
level of the	adjust UP until the image is not modulated by
image when	loud (full volume) audio into the Transmitter.
using a LX2,	Store this Clamp setting.
LS2, DP9240,
DP9260, Pro
AV 9320, Pro
AV 9400, Pro
AV 9400+,
and Pro AV
9410
Colors	Adjust the Clamp level in your projector. To do
appeared	this select Menu, PC Adjust, Free Mode. In Free
washed out	Mode select the ￿ menu item. Select Clamp and
when using a	adjust until the colors are not washed out. Store
LX2, LS2,	this Clamp setting.
DP9240,
DP9260, Pro
AV 9320, Pro
AV 9400, Pro
AV 9400+,
and Pro AV
9410
No sound	Ensure the UTP LEDs on both the transmitter and
	receiver are solid green.
	Make sure that audio from input sources are cor-
	rectly connected to the transmitter.
	Verify the audio outputs are properly connected
	to the projector.
	Adjust the audio level on the projector.
Remote con-	Ensure the dip-switch settings are set correctly for
trol does not	your projector.
control Projec-	Make sure the RS-232 output on the receiver is
tionLink	connected correctly to the projector.
	Check the batteries on the remote control

ProjectionLink User & Installation Guide 47