3M 2100 manual 924-5, Tension in cable should be 3/16 Maximum

Page 18

	MODEL 2100 OVERHEAD PROJECTOR
COLOR TUNING CABLE	COLOR TUNING CABLE
(Before Serial Number 422868)	(After Serial Number 422868)
NOTE	No adjustment.
Tension in cable should be 3/16"
maximum.

A.Raise the Top Cover Assembly by pulling the Release Latch and lift up. (See Figure)

B.Turn the Color Tuning Knob clockwise to the maximum.

C.While holding the Cable Screw, loosen the Cable Nut. Using pliers, pull the slack out of the cable.

D.Retighten Cable Nut and Screw. (See Figure)

9/924-5

Image 18

Contents Model 2100 Overhead Projector Table of Contents Technical Support Hotline 1-800-328-1371 U.S. & CanadaIntroduction PhysicalModel 2100 Overhead Projector Optical Electrical 2130/2140/2150 2160/2170/2180 4130/4140/41Mechanical 2130/2140/2150 2160/2170/2180 4130/41 40/4150Principles of Operation Operation and Maintenance Do not look in the front projection lens when lamp is onCUS Knob Method Cleaning Stage Glass and Fresnel Lens MirrorsLamp Changer Assembly Before S/N After S/N Troubleshooting Symptom Check CAUSE/SOLUTIONSTroubleshooting Field Kits AvailableAdjustments If floor or ceiling lines are not Optical Alignment Focus Mechanism 924-5 Tension in cable should be 3/16 MaximumPost should Fold Down Without TOO Much Force Page Page Page Page Page Page Page Page DISASSEMBLY/RE-ASSEMBLY Stage Glass Focusing Assembly How to remove and install the condenser lens when equipped