MODEL 2100 OVERHEAD PROJECTOR
SECTION 6 DISASSEMBLY/RE-ASSEMBLY
PROJECTION HEAD ASSEMBLY (DOUBLET) | TOP COVER ASSEMBLY |
1.To disassemble Head Assembly from Head Support Bracket:
A.Remove Screw Cap from Top Shroud.
B.Remove the three screws (“A”).
C.Slide the Head Assembly off Support Bracket.
1.Raise the Top Cover Assembly by pulling the Release Lever and lifting up.
2.Using both hands, pull either one of the two hinges outward until the hinge pin is out of the hole. Slide the complete TOP COVER ASSEMBLY in the opposite direction to release the second hinge and lift up and out.
2.To disassemble Head Assembly from Head Support Bracket:
A.Remove the two screws (“A”).
B.Lift the Top Shroud off assembly.
C.Remove the three screws (“B”).
D.Slide the Head Assembly off Support Bracket.
FRESNEL LENS
1.Remove Top Cover Assembly. (See Figure above)
2.Loosen the four (4) screws holding the four
(4) corner clips and lens. DO NOT REMOVE SCREWS. Turn clips to side and remove lens.
NOTE
When replacing the Fresnel Lens, make certain the bow in the lens is in the convex (upward) position when projector is upright.
See Section 4, page
9/92 |