3M X55I manual Image Menu, Over Scan, Position, Phase

3M™ Digital Projector S55i/X55i

Multifunctional settings

IMAGE Menu

With the IMAGE menu, items shown in the table below can be performed.

Select an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to execute the item. Then perform it referring to the following table.

MENU [RGB]	:SELECT
PICTURE	ASPECT         4:3
IMAGE	OVER SCAN      5
INPUT	V POSITION     25
SETUP	H POSITION     142
SCREEN	H PHASE        16
OPTION	H SIZE         1344
EASY MENU	AUTO ADJUST EXECUTE

Item	Description
	Using the buttons ▲/▼ switches the mode for aspect ratio.
	For an RGB signal
	4:3  16:9  NORMAL
ASPECT	For a video signal / no signal
	4:3  16:9  SMALL
	• The NORMAL mode keeps the original aspect ratio of the signal.
	• For an HDTV signal of 1125i (1080i) or 750p (720p) as the
	COMPONENT VIDEO input, this item can't be selected.
	Using the buttons ▲/▼ adjusts the over-scan ratio.
OVER SCAN	Large (It reduces picture)  Small (It magnifies picture)
	• This item can be selected only for a video signal.
	• When this adjustment is too large, certain degradation may appear
	at the frame area of the picture. In such a case, please adjust small.
	Using the buttons ▲/▼ adjusts the vertical position.
	Up  Down
V POSITION	• Over-adjusting the vertical position may cause noise to appear
	on the screen. If this occurs please reset the vertical position to the
	default setting. Pressing the RESET button when V POSITION is
	selected will reset the V POSITION to the default setting.
	Using the buttons ▲/▼ adjusts the horizontal position.
	Left  Right
H POSITION	• Over-adjusting the horizontal position may cause noise to appear
	on the screen. If this occurs please reset the horizontal position to
	the default setting. Pressing the RESET button when H POSITION
	is selected will reset the H POSITION to the default setting.
	Using the buttons ▲/▼ adjusts the horizontal phase to eliminate
	flicker.
H PHASE	Right  Left
	• This item can be selected only for an RGB signal or a component
	video signal. Note that this does not work with the input signal of
	525i(480i)/625i(576i)/SCART RGB from the component video port.
30	© 3M 2005. All Rights Reserved.