Onkyo TX-SR674E, TX-SR8467 Using the Remote Control in Zone, Adjusting the Volume for Zone

Zone 2—Continued

Adjusting the Volume for Zone 2

ZONE 2 LEVEL ,

Using the Remote Control in Zone 2

To use the remote controller to control the AV receiver from Zone 2, you’ll need one of the following commer- cially available multiroom remote control kits:

•Multiroom Kits are made by Niles and Xantech. These kits can also be used when the AV receiver is not in line of sight of the remote controller, for example, when it’s installed inside a cabinet.

Using a Multiroom Kit with Zone 2

Remote

controller

ZONE2

On the remote controller, press the [ZONE 2] button, and then use the [LEVEL–] and [LEVEL+] buttons.

In the following diagram, an IR receiver picks up the infrared signals from the remote controller in Zone 2 and feeds them to the AV receiver in the main room via the connecting block.

LEVEL- LEVEL+

AV receiver

On the AV receiver, use the ZONE 2 LEVEL []/[ ] buttons.

Connecting block

Main room

IR receiver

Remote controller

Zone 2

If your Zone 2 speakers are connected to an amp in Zone 2, use its volume control to adjust the volume.

Signal flow

Connect the miniplug cable from the connecting block to the AV receiver’s IR IN jack as shown below.

To Mute Zone 2:

Press the remote controller’s [ZONE 2] button, followed by the [MUTING] button. To unmute Zone 2, press the remote controller’s [ZONE 2] button again, followed by the [MUTING] button, or adjust the volume for Zone 2.

Notes:

•Only analog input sources are output by the ZONE 2 LINE OUT and ZONE 2 SPEAKERS terminals. Dig- ital input sources are not output. If no sound is heard when an input source is selected, check if it’s con- nected to an analog input.

•While Zone 2 is being used, listening modes that need surround back speakers (i.e., Dolby Digital EX and DTS-ES) are unavailable.

•While Zone 2 is on, functions will not work.

•You can’t select different radio stations for Zone 2 and the main room. For example, if you have an FM sta- tion for the main room, that station will also be used in Zone 2.

from the connecting block

Miniplug cable

Using a Multiroom Kit with a Cabinet

In the following diagram, an IR receiver picks up the infrared signals from the remote controller and feeds them to the AV receiver in the cabinet via the connecting block.

IR receiver Connecting

block

IR IN

Inside
cabinet	Remote controller
Signal flow

82