Knoll HD284 user manual Ul, Cul, Tüv, Nom, Iram, Gost, Ccc, Mic, S-Jqa

Page 2

2

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

Canada

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Safety Certifications

UL, CUL, TÜV, NOM, IRAM, GOST, CCC, MIC, S-JQA

Declaration of Conformity

Knoll Systems, 11791 Machrina Way, #120, Richmond, BC V7A 4V3 Canada

We declare under our sole responsibility that the HD284 projector conforms to the following directives and norms:

EMC Directive 89/336/EEC, Amended by 93/68/EEC EMC: EN 55022

EN 55024 EN 61000-3-2 EN 61000-3-3

Low Voltage Directive 73/23/EEC, Amended by 93/68/EEC Safety: EN 60950: 2000

October, 2002

Australian Certification C-tick mark

Trademarks

Apple, Macintosh, and PowerBook are trademarks or registered trademarks of Apple Computer, Inc. IBM is a trademark or registered trademark of International Business Machines, Inc. Microsoft, PowerPoint, and Windows are trademarks or registered trademarks of Microsoft Corporation. Digital Light Processing is a trademark or registered trademark of Texas Instruments. Faroudja, DCDi, and TrueLife are trademarks or registered trademarks of Faroudja. Knoll is a trademark or registered trademark of Pacific Sound & Signal Inc.

WARNING: This product contains chemicals, including lead, known to the State of California to cause birth defects or other reproductive harm. Wash hands after handling.

WARNING: This product has a lamp, which contains a very small amount of mercury. Dispose of it as required by local, state, or federal ordinances and regulations. For more information, see www.eiae.org.

Image 2
Contents HD284 UL, CUL, TÜV, NOM, IRAM, GOST, CCC, MIC, S-JQA Table of Contents Safety Instructions Knoll HD284 Introduction Usage GuidelinesSetting UP the Projector Projector PositioningRear Connector Panel HD284 Projection Distances 169 ImageConnecting a Video Device Video ConnectionsConnecting a Video Device Displaying a video image Connecting the power cableDisplaying an Image Video or Computer Connecting to a computer Shutting down the projector Troubleshooting your setupPower Save Turning off the projectorPage Page Using the projector keypad buttons Using the remote control Troubleshooting the remoteCustomizing the projector Using the menusOptimizing video images Picture menu Page Page Advanced settings Settings menu Following options are for computer or Hdtv sources onlySystem Maintenance Cleaning the lensReplacing the projection lamp Loosen the captive screw on the lamp moduleSpecifications Resetting the lamp timerRed LED behavior and projector errors Page Page RS232 Terminal Specifications and Commands Supported commands GCG RCG Limited Warranty