Knoll HD284 user manual

Page 20

20

Natural Wide: this mode stretches a 4:3 image to fill the entire 16:9 screen. The center two-thirds of the image is unchanged; the edges of the image are stretched.

Presets: This allows you to customize settings and save the settings to be restored later. To restore the factory default settings, choose Factory Reset in the Settings>Service menu.

To set a preset for the current source, adjust the image, select Save Settings in the Presets menu, then choose Save User 1, 2, or 3. You can recall these settings in the future by selecting the appropriate user presets.

Image 20

Contents HD284 UL, CUL, TÜV, NOM, IRAM, GOST, CCC, MIC, S-JQA Table of Contents Safety Instructions Knoll HD284 Introduction Usage GuidelinesSetting UP the Projector Projector PositioningRear Connector Panel HD284 Projection Distances 169 ImageConnecting a Video Device Video ConnectionsConnecting a Video Device Displaying a video image Connecting the power cableDisplaying an Image Video or Computer Connecting to a computer Troubleshooting your setup Power SaveShutting down the projector Turning off the projectorPage Page Using the projector keypad buttons Using the remote control Troubleshooting the remoteCustomizing the projector Using the menusOptimizing video images Picture menu Page Page Advanced settings Settings menu Following options are for computer or Hdtv sources onlySystem Maintenance Cleaning the lensReplacing the projection lamp Loosen the captive screw on the lamp moduleSpecifications Resetting the lamp timerRed LED behavior and projector errors Page Page RS232 Terminal Specifications and Commands Supported commands GCG RCG Limited Warranty