Onkyo TX-NR709 Input/Output Assign, Monitor Out, Sub, Hdmi OUT SUB, Hdmi OUT Main

Input/Output Assign

Monitor Out

If you connect your TV to HDMI output, “Monitor Out” setting is automatically set so that the onscreen setup menus are displayed and composite video, S-Video, and component video sources are upconverted* and output.

Note

•See “Video Connection Formats” (➔ page 83) for charts showing how the “Monitor Out” and “Resolution” settings affect the video signal flow through the AV receiver.

■Monitor Out

`HDMI Main:

Select this if your TV is connected to HDMI OUT MAIN.

`HDMI Sub:

Select this if your TV is connected to HDMI OUT

SUB.

`Both:

Select this if your TVs are connected to HDMI OUT MAIN and HDMI OUT SUB. Video signals are output from both HDMI outputs at the resolution supported by both TVs.

`Both(Main):

Select this if your TVs are connected to HDMI OUT MAIN and HDMI OUT SUB. Video signals are output from both HDMI outputs but HDMI OUT MAIN will become a priority; depending on the resolution, video signals may not be output from

HDMI OUT SUB.

`Both(Sub):

Select this if your TVs are connected to HDMI OUT MAIN and HDMI OUT SUB. Video signals are output from both HDMI outputs but HDMI OUT SUB will become a priority; depending on the resolution, video signals may not be output from

HDMI OUT MAIN.

Note

•When using the DeepColor function, if the “Monitor Out” setting is set to “Both(Main)” or “Both(Sub)”, the number of bits may be limited due to the capability of your TV connected to a priority output.

■Resolution

`Through:

Select this to pass video through the AV receiver at the same resolution and with no conversion.

`Auto:

Select this to have the AV receiver automatically convert video at resolutions supported by your TV.

`480p (480p/576p), 720p, 1080i, 1080p: Select the desired output resolution.

`1080p/24:

Select this for 1080p output at 24 frames per second.

`4K Upscaling:

Select this for an output resolution four times that of 1080p, resulting in 3840 × 2160 pixels.

You can specify the output resolution for the HDMI OUT MAIN and have the AV receiver upconvert the picture resolution as necessary to match the resolution supported by your TV.

Note

•Depending on the incoming video signal, the video playback may not be smooth or the vertical resolution may be lowered. In this case select anything other than “1080p/24”.

•If the “Monitor Out” setting is set to “Both”, this setting is fixed to “Auto”.

•When “Monitor Out” is set to either “HDMI Sub” or

“Both(Sub)”, the “Resolution” setting is fixed to “Through”.