Onkyo TX-NR709 instruction manual Controlling Zone 2 Components, Adjusting the Volume for Zone

Controlling Zone 2 Components

■Operating on the AV receiver

Input selector buttons

ZONE 2 OFF MASTER VOLUME

1 To turn on Zone 2 and select an input source, press ZONE 2 followed by an input selector button within 8 seconds.

Zone 2 turns on, the Z2 indicator lights on the display.

Tip

• The corresponding trigger output goes high (+12 V).

To select AM or FM, press the TUNER input selector button repeatedly.

To select the same source as the main room’s, press ZONE 2 repeatedly until “Z2 Selector: Source” appears on the display.

To turn off Zone 2, press OFF.

The zone is turned off.

Tip

•The corresponding trigger output goes low (0 volts).

■Operating on the remote controller

To control Zone 2, you must press ZONE2 on the remote controller first.

8RECEIVER

ZONE2

Input selector buttons

MUTING

VOLq/w

1 Press ZONE2 and then press 8RECEIVER.

Zone 2 turns on, the Z2 indicator lights on the display.

Tip

• The corresponding trigger output goes high (+12 V).

En

2 To select an input source for Zone 2, press ZONE2, followed by an input selector button.

To select AM or FM, press the TUNER input selector repeatedly.

Note

•You cannot select different AM or FM radio stations for your main room and Zone 2. The same AM/FM radio station will be heard in each room.

3 To turn off Zone 2, press ZONE2 followed by 8RECEIVER.

Tip

• The corresponding trigger output goes low (0 volts).

Adjusting the Volume for Zone 2

■Operating on the remote controller

1 Press ZONE2.

2 Use VOL q/wto adjust the volume.

■Operating on the AV receiver

1	Press ZONE 2 (the Z2 indicator on the display
	flash).
2	Use MASTER VOLUME control within 8 seconds
	to adjust the volume.

If your Zone 2 speakers are connected to a receiver or integrated amp in Zone 2, use its volume control to adjust the volume.

64