Onkyo HT-R690 Remote Controller Setup, Lock Setup, Using the Audio Settings, Bass, Treble

Remote Controller Setup

Main menu Remote Controller Setup

Remote Mode Setup

See “Looking up for Remote Control Code” (➔ page 61).

Lock Setup

With this preference, you can protect your settings by locking the setup menus.

Main menu Lock Setup

■Setup

`Locked

`Unlocked

When “Locked” is selected, the setup menus will be locked and you cannot change any setting.

Using the Audio Settings

You can change various audio settings from the Home menu (➔ page 36).

1	Press RECEIVER followed by HOME.
2	Use q/wand ENTER to select “Audio”, and then
	use q/w/e/rto make the desired selection.

Note

•These settings are not available in either of the following cases:

–a pair of headphones is connected.

–the “Audio TV Out” setting is set to “On” (➔ page 52).

–“HDMI Control (RIHD)” is set to “On” (➔ page 51) and you’re listening through your TV speakers.

Tone Control Settings

■Bass

`–10dBto 0dB to +10dB in 2 dB steps.

You can boost or cut low-frequency sounds output from the front speakers.

■Treble

`–10dBto 0dB to +10dB in 2 dB steps.

You can boost or cut high-frequency sounds output from the front speakers.

You can adjust the bass and treble for the front speakers, except when the Direct is selected.

En

Operating on the AV receiver

1	Press TONE repeatedly to select either “Bass” or
	“Treble”.
2	Use + and – to adjust.

Speaker Levels

■Subwoofer Level

`–15dBto 0dB to +12dB in 1 dB steps.

■Center Level

`–12dBto 0dB to +12dB in 1 dB steps.

You can adjust the volume of each speaker while listening to an input source.

These temporary adjustments are cancelled when the AV receiver is set to standby. To save the setting you made here, go to “Level Calibration” (➔ page 43) before setting the AV receiver to standby.

Note

•You cannot use this function while the AV receiver is muted.

•Speakers that are set to “No” or “None” in

“Speaker Configuration” (➔ page 42) cannot be adjusted.

Audyssey

■Audyssey

See “Audyssey” in “Source Setup” (➔ page 45).

■Dynamic EQ

See “Dynamic EQ” in “Source Setup” (➔ page 45).

■Dynamic Volume

See “Dynamic Volume” in “Source Setup” (➔ page 46).

Note

•These technologies can be used when all the following conditions are met:

–Room Correction and Speaker Setup is completed. Note that “Audyssey” requires the “Audyssey 2EQ Full Calibration” method.

–Any listening mode other than Direct is selected.

–A pair of headphones is not connected.

•The setting is stored individually for each input selector.

54