Mitsubishi Electronics WD3300U user manual ProjectorView main screen, EN-13

ProjectorView (continued)

5	The password input screen appears. Enter the
	password you set.
	• The default password is admin.
	(Note)
	If you input a wrong password 4 successive times,
	the Web browser is closed. In this case, repeat from
	step 1.
6	The ProjectorView main screen appears. Click
	anywhere on the screen.
	• The screen may not show the latest information
	unless you click on the screen.
	• Some buttons may not be displayed. In this case,
	select [Start] - [Control Panel] - [Java Plug-in] and
	disable the cache.

(Note)

On Projector-Control Device Installer window, when double-clicking the update button after starting ProjectorView and then inputting password, the window indicating a script error may appear infrequently. However, this is not something that affects the operation. If the error window appears, close it by pressing “Yes” or “No” button.

[ProjectorView main screen]

Press to display the Setup window. (See page 15.)

Press to control the projector. For the functions of these buttons, see the User Manual of the projector.

• The DIGITAL 1 button is for HDMI input and the DIGITAL 2 button is for DVI input.

Projector information is displayed. To display the projector information, set LAN-Controlled Mode to ON (1) (see page 10) and enter necessary information on the Projector Setup screen (see page 15) in advance.

Failures in the projector are indicated with dots. When you place the mouse cursor to a dot, the indicated failure is described in the box at the bottom.

(Note)

•When mute is on, you cannot change the lamp mode. If you try to change the lamp mode, a dot appears next to “Command error” of WARNINGS.

•Though the dot of “Command error” is sometimes lit at the time of power-on, this is not a malfunction. When you press the Power ON button again after several seconds, the dot goes out.

EN-13