Mitsubishi Electronics WD3300U user manual Telnet setting, EN-8

Preparation/SetUp (continued)

Telnet setting

Setting of password, display language, LAN control, and PJLink™ certification using telnet.

This section describes how to set the password, display language on the ProjectorView screen, LAN control, and PJLink™ certification that are necessary for the operation state control tool (commercially available) that uses the projector operation control/monitor tool ProjectorView and the industry standard PJLink™ protocol.

1	Start the Projector-Control Device Installer.
	• Select [Start] - [All Programs] - [Projector] -
	[Projector-Control Device Installer] (in the case of
	Windows® XP).
2	Press the + buttons on the left pane to expand the
	tree structure until the IP address you set appears.

3 Click the Telnet Configuration tab.

4	Select the Connect tab. Press the Enter key within
	5 seconds after the message shown on the right
	appears.
	• When it passes 5 seconds without any operation
	on this screen, the screen is shaded and no key
	operation is accepted. In this case, click the
	Connect button again to continue setting.

5

The setting menu appears.

EN-8