Mitsubishi Electronics WD3300U user manual Setting the IP address of the projector, EN-5

Preparation/SetUp (continued)

Setting the IP address of the projector

Before setting the IP address, check that the projector has been LAN-networked and turn on the main power of the projector.

•When using multiple projectors, connect and configure them one by one. If you turn on the powers of the projectors that are connected but not yet configured at the same time, they may not be recognized.

1Start the Projector-Control Device Installer.

•Select [Start] - [All Programs] - [Projector] - [Projector-Control Device Installer] (in the case of Windows® XP).

2Click the Search button.

•Projector is recognized.

(Note)

When projector isn’t recognized, check the following.

• The firewall function has been disabled. (When it has been enabled, search may not be conducted.)

• The personal computer and the projector are on the same network. (For preventing unauthorized access.)

• More than one Projector-Control Device Installer isn’t running.

• The network adapter being used is selected by the Option setting of the Tool menu.

• “STANDBY MODE” of the projector is set to “STANDARD.”

3	Select a projector by clicking the line showing the
	projector and click the Assign IP button.

Click here

4

The Assign IP Address screen appears.

•For automatic IP address setting by the DHCP server, go to page 6. For IP address setting without using the DHCP server, go to page 7.

EN-5