Mitsubishi Electronics WL639U Viewing computer images, Connecting the projector to a computer

Viewing computer images

A. Connecting the projector to a computer

Preparation:

•Make sure that the power of the projector and that of the computer are turned off.

•When connecting the projector to a desktop computer, disconnect the RGB cable that is connected to the monitor.

Computer

COMPUTER/COMPONENT

VIDEO IN-1/IN-2

1

 To monitor port

RGB cable

For analog connection:

1.Connect one end of the supplied RGB cable to the COMPUTER/COMPONENT VIDEO IN-1/IN-2 terminal of the projector.

2.Connect the other end of the RGB cable to the monitor port of the computer.

•Additional devices, such as a conversion connector and an analog RGB output adapter, are required depending on the type of the computer to be connected.

Computer

COMPUTER/COMPONENT

VIDEO DVI-D (HDCP)

1
	To DVI
	DVI cable
	(option)

Computer

AUDIO IN-1/IN-

AUDIO OUT

PC audio cable (option)

To PC audio output

Monitor

MONITOR OUT

RGB cable

For digital connection:

1.Connect one end of a commercially available DVI cable to the COMPUTER/COMPONENT VIDEO DVI-D (HDCP) terminal of the projector.

2.Connect the other end of the DVI cable to the DVI terminal of the computer.

For audio connection:

•This projector uses stereo pin jack for its audio input. Check the type of the audio output terminal of the connected computer and prepare a proper cable for connection. Some computers don’t have the audio output terminal.

•When the audio cable is connected to the AUDIO OUT ter- minal, the speaker output is muted.

For monitor connection:

1.Connect the RGB cable from the monitor to the MONITOR OUT terminal of the projector.

•Use of a long cable may decrease the quality of projected images.

•Images may not be projected correctly, depending on the type of the connected computer.

•Also read the instruction manual of the equipment to be connected.

•Contact your dealer for details of connection.

EN-13