Troubleshooting
If problems with the unit persist even after you followed the suggestions below, please stop using the unit, disconnect the power cord and contact the retailer from whom you purchased the unit.
| Description of problem | Please check the following |
|
|
|
| The unit does not turn on. | • Is the power cord properly plugged in? |
|
| • Is the EXTERNAL CONTROL switch set to ON though the DC 12 V OUT |
|
| terminal of the recorder and the CONT IN terminal of this unit are not |
|
| connected ? |
|
|
|
| This unit does not work | • Is the USB cable connected correctly? |
| correctly. | • Are the menus set correctly in the recorder? |
|
| • Is the number of recording devices connected within the limitation? |
|
| • Does the HDD 1 or HDD 2 indicator blink or illuminate red? |
|
| • Is the MODE rotary switch set correctly? |
|
| • Is the information of this unit displayed on the menu for registering the |
|
| device? |
|
| Is the correct data capacity displayed? |
|
| • Did you delete the management information before changing the HDD |
|
| operation mode? |
|
|
|
| TEMP indicator illuminates. | • Turn off the power. Turn on the power again after the internal temperature |
|
| drops. |
|
|
|
| FAN indicator illuminates. | • Replace the fan with a new one. Ask your dealer to replace the fan. |
|
|
|
Maintenance
The elapsed operating time, which can be a guide to know the periodic maintenance timing, is available in the menu of the recorder. Refer to the manual of the recorder. The indication of the operating time of the recorder may vary from the actual operating time. It is recommended to use this indication just for your reference.
When this unit is registered as a Main device, the elapsed operating time of this unit is not displayed. (The elapsed operating time of the recorder connected with this unit is displayed.)
ENGLISH
19