Mitsubishi Electronics FD730U-G user manual Indicators, Normal condition, Abnormal condition

Indicators

This projector has two indicators, each of which shows the operation condition of the projector.

The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your dealer.

					STATUS indicator	POWER indicator
Normal condition
POWER		STATUS			CONDITION		NOTE
			Off		Stand-by
Steady red					Lamp stand-by for power-off		The power cannot be turned on by pressing
		Blinking green					the POWER button.
					Lamp stand-by for power-on		The power cannot be turned off by pressing
		Blinking green					the POWER button.
Steady green
					The power is on. (Normal condition)
		Steady green
Abnormal condition
POWER		STATUS			CONDITION		POSSIBLE SOLUTION
					Abnormal temperature		• Clean the vents.
Steady green					• The vents are clogged with dust or dirt.		• Relocate the projector to a cooler place.
	or				• The room temperature is high.
		Blinking orange
Steady red
					The protection circuit is working or the lamp is		• Wait until the STATUS indicator goes
					in an abnormal condition.		out, then press the POWER button.
Steady red		Blinking green					• If the above solution is not effective,
							replace the lamp.
					The lamp operation time exceeds the time		Replace the lamp.
					elapsed until the lamp lifetime notice while the		Change with a new lamp if this problem
Steady green		Blinking green/red
					power is on. (See page 38.)		recurs.
					The lamp operation time exceeds the time
					elapsed until the lamp lifetime notice while the
Steady red		Blinking red
					power is off. (See page 38.)
					The lamp operation time exceeds the time
Steady red		Steady red			elapsed until the lamp lifetime. (See page 38.)
					The lamp cover isn’t closed.		Close the cover correctly.
			Off
Blinking green/red
					Abnormal.		Contact your dealer.
		Steady
				or
Blinking green/red
		Blinking

EN-43