Mitsubishi Electronics FD730U-G user manual Specifications, Ypbpr/Ycbcr

Specifications

Type	DLP™ projector
Model	FD730U/FD730U-G
Rated power supply	100 - 240 V AC, 50/60 Hz
Power consumption	4.2 A
	During standby: 0.5W (when STANDBY MODE is LOW)
Display Technology	0.65-inch single chip Digital Micromirror Device (DMD)
	Pixels: 1920 x 1080 = 2073600 pixels
Colors	16770000 colors
Projection lens	F 2.4-2.8, f = 20.6-30.1 mm
Light source lamp	280 W
Picture size	40–300 inch (Wide) (aspect ratio 16:9)
PC compatibility	Maximum resolution: 1920 x 1080 dots (Compressed in the case of 1600 x 1200 dots)
	Panel resolution: 1920 x 1080 dots
Video compatibility	NTSC/NTSC 4.43/PAL (including PAL-M, N)/SECAM/PAL-60
	Component Video (DVD/HDTV) (480i, 576i, 480p, 576p, 1080i, 720p, 1080p)
Speaker	10 W mono x 1
S-video input	Luminance signal: 1.0 Vp-p 75 Ω (negative sync.)
	Chroma signal: 0.286 Vp-p 75 Ω (burst signal)
Video input	1.0 Vp-p 75 Ω (negative sync.)
Audio input	350 mVrms, 10 kΩ or more
Analog RGB input	RGB: 0.7 Vp-p 75 Ω (negative sync.)
	YPBPR/YCBCR:
	Y: 1.0 Vp-p (negative sync.)
	PBPR/CBCR: 0.7 Vp-p
	HD/CS: TTL level (positive or negative)
	VD: TTL level (positive or negative)
HDMI input	HDMI 19-pin
	HDMI interface (TMDS single link) (only PCM audio is supported)
Control connector	SERIAL terminal (RS-232C), LAN terminal (RJ-45)
Outside dimensions	345 x 134 x 270 mm (width x height x depth)
Weight	Approx. 4.3 kg
Length of power cord	71 inch (1.8 m)
Temperature, humidity	+41°F (+5°C) - +95°F (+35°C), 30 - 90%
(performance guaranteed)

• The specifications and outside appearance of the projector are subject to change without prior notice.

EN-44