PLUS Vision U5-512, U5-632, U5-532 user manual Replacing the Lamp Cartridge

Page 65

Replacing the Lamp Cartridge

•The lamp that is used as a light source in the projector has a limited service life. The rated service life of the lamp is about 2000 hours (when used in normal mode only). This could be shortened depending on conditions of use and other factors.

Note that lamp life will be extended when the projector is often used in Eco mode. (The rated service life of the lamp means the average value of lamp life for lamps that have been manufactured over a long period, and it is derived from test conditions at this company.)

•When the life of the lamp is exceeded, the STATUS indicator lights a steady red and the message [Replace the Lamp Cartridge] is displayed on the screen. When this occurs, it is time to replace the lamp cartridge. Please make the replacement following the procedure below.

•If the projector is used another 100 hours after the lamp’s service life is reached, the power is set to the standby mode and no longer turns on.

•Contact a store that sells the U5-632/U5-532/U5-512 for a replacement lamp. Indicate you need a U5-200 replacement lamp for the U5-632/U5-532/U5-512 (order code 28-050).

CAUTION

•Replacement of the lamp cartridge is performed after switching off the power, waiting for the cooling fan to stop, disconnecting the power plug from the power outlet, and then leaving the projector for about 60 minutes before replacement is started. Replacement of the lamp cartridge during operation or immediately after operation stops will cause burns because of the high temperature.

•Do not remove any screws other than those specified.

•Do not touch the lamp with bare hands. Doing so could shorten the life of the lamp.

•If lamp has reached the end of its usable life, the lamp bulb may shatter. When this happens, an explosive sound can be heard and pieces of glass may be scattered in the lamp cartridge. Do not touch them as the pieces of glass may cause injury. If this happens, contact your dealer or the store the projector was purchased.

E-64

Page 64 Page 66
Image 65
Page 64 Page 66
Contents U5-632 U5-532/U5-512 Do not look at the laser pointer’s light source PrecautionsThis label is located on the side of the remote control DOC Compliance Notice Important Safety InformationPower Supply InstallationCleaning Lamp ReplacementMajor Features Table of Contents Table of Contents Checking the Supplied Accessories Storage case for projector and accessories Checking the Supplied AccessoriesUSB cable type A, 2 m / 6.6 feet Velcro strap Pocket Cable storage pouchApplicable Projector U5-532/U5 Nats Names of the Main Unit PartsZoom ring E-26 Exhaust Vents Focus ring E-27 Lens Lens capNames of the Main Unit Parts Built-in Security SlotNames of the Remote Control Parts Names of Parts/Preparing the Remote Control UnitIncluded with the U5-632 Inserting the BatteriesTemporarily cancels the video Audio Number buttons E-37 Replacement MethodRGB button and Video button Used for the security lockSide View Top View Remote Control RangeSide View Procedure Up to Projecting to the Screen U5-632 Screen Size and Projection Distance Placement GuideU5-532/U5-512 Screen Size and Projection Distance Placement GuideConnections with Personal Computer Personal computer RGB signal cable Supplied itemManufacturer Model Key To Output the External Output Signal of a Notebook ComputerConnecting Personal Computers and Video Equipment Video Equipment with Video Connectors Connections with Composite SignalsVideo Equipment with S-VIDEO Connectors → Video See Input Format on Page E-56Component cable Available as an option Order code Connections with Component SignalsGreen Blue Red Cb Cr Pb Pr Green Blue RedAudio cable Supplied item Connections with the Audio JackAudio cable Supplied item Audio conversion adapter Red Connecting Personal Computers and Video Equipment Operating Switch on the projector powerPress the Enter button to set Power Cable Connections and Switching the Power On/OffThis completes the selection of the display language CursorStandby button on main unit Unplug the power cableFinishing Adjustment of the Projection Screen Adjustment of the Projection ScreenAdjust the projection image to the screen Zoom ringAdjuster button Making Adjustments with the AdjustersFocus ring Raising the projection imageWhen Auto Source is On Automatic AdjustmentWhen Auto Source is Off General OperationGeneral Operation Video Signals / Component SignalsSelection of Aspect Ratio Freezing a Moving Picture Cancelling Video and Audio TemporarilyLamp Mode Keystone Adjustment of the VolumePress the Cancel button to immediately close the display Press the Zoom button to enlarge the image Enlargement of the Image and Video MovementImage can also be moved in the following circumstances Using the Presentation Timer Operation Using the Laser PointerClick button on back Connecting the computer and projectorJOG buttons Click buttonUse as a High-Brightness Monochrome Projector Controlling the Projector from ComputerApplicable Projector U5-632 Serial cable D-Sub 9-pin, straight commercially availableExample Registering the password Use the number buttons 1 to 4 to register the passwordProtecting the Projector with the Security Lock All four placesCanceling the password/Changing the password Input the password using the number buttons 1 toCanceling the password Changing the passwordContent of Adjustments and Settings Using the Quick MenuPress the cursor or button to make the adjustment To close the display immediately, press the Cancel buttonMenu button Menu Operation MethodSelect buttons Enter buttonMenu Operation Method Menu Screen Names and FunctionsMenu Display Press the Menu button to display the menu Performing Menu OperationsSub menu Making Adjustments/SettingsThis condition al- lows selection of the item name Selecting Another Menu Name with Remote Control Operation View ColorColor B/W Switching Menu name Item Name Sub Menu SetupVideo OptionImage Picture Adj. Picture AdjustmentBrightness / Contrast / Color / Tint / Sharpness Picture Adj. / Fine Picture / H Position / V PositionPress of the Enter button forces the reset ResetFine Picture PositionColor Select the preset color modeQuick Color Adj GammaColor Temp Selection contents at the time of YPbPr inputWhite Color SpaceWhite Balance View Video SignalsAspect FilterVertical Flip Power cable has been unpluggedKeystone Save ViewColor B/W Switching SetupAuto Power Off Auto SourceStatus indicator is green SetupStatus indicator is off Menu PositionTo start the timer Presentation TimerInput Format Video and S-VideoLanguage OptionOn Screen BackgroundOption Startup ScreenSecurity Lock Lamp Timer Reset Factory DefaultInfo StatusInfo Resolution / FrequencyLamp Timer Thermal Protector When an Indicator is Lit or FlashingCheck the following matters before requesting servicing TroubleshootingCleaning a Soiled Projector Main Unit CleaningCleaning the Inside of the Projector Dirty LensReplacing the Lamp Cartridge Remove the lamp cartridge Replacing the Lamp CartridgeMount the lamp cover Reset the Lamp TimerMount the new lamp cartridge Optical SpecificationsElectrical MechanicalModel U5-532/U5-512 SpecificationsU5-532 U5-512Resolution Frequency Video SignalTable of Supported Frequency U5-632/U5-532216 Cabinet Dimensions240 216 Unit mm inch2005

U5-512, U5-532, U5-632 specifications

The PLUS Vision U5 series includes three impressive models: the U5-532, U5-512, and U5-632. Each model is designed with advanced features and technologies geared towards enhancing visual presentations, making them ideal for business, education, and personal use.

Starting with the U5-532, this model is equipped with a high-resolution display that provides stunning clarity and vibrant colors. Its native resolution ensures that text and images are displayed crisply, making it perfect for detailed presentations. The U5-532 supports multiple connectivity options, including HDMI and USB, allowing users to connect various devices effortlessly. Additionally, it features built-in speakers that deliver clear audio, eliminating the need for external sound systems.

Moving on to the U5-512, this model places a strong emphasis on portability without sacrificing performance. Weighing significantly less than its counterparts, the U5-512 is easy to transport, making it suitable for on-the-go professionals or educators. It supports wireless connectivity, allowing users to mirror their smartphone or tablet displays effortlessly. The model also includes a rechargeable battery, giving users the flexibility to present without being tethered to a power source.

Lastly, the U5-632 stands out with its enhanced brightness and superior contrast ratios. This model is perfect for environments with a lot of ambient light, as it ensures that presentations remain visible even in challenging conditions. In addition to its robust connectivity options, the U5-632 employs advanced image processing technology, which enhances the quality of images and video playback.

Across the entire U5 series, users will find intuitive control interfaces that make navigation easy. The devices come with a remote control, adding convenience for presenters who need to manage their presentations from a distance. Furthermore, the U5 models are designed with energy efficiency in mind, contributing to reduced power consumption without compromising performance.

In summary, the PLUS Vision U5-532, U5-512, and U5-632 represent a significant advancement in presentation technology, each tailored to meet specific user needs. Their blend of high-quality displays, versatility in connectivity, and user-friendly interfaces makes them exceptional tools for anyone looking to make an impact with visual communication.
Top Page Image Contents