Onkyo TX-NR808 Lock Setup, Using the Audio Settings, Tone Control Settings, Speaker Levels

■Receiver

`via NET:

You can update the firmware via Internet. Check the network connection before update.

`via USB:

You can update the firmware from a USB mass stor- age device.

You can update the AV receiver’s firmware. Do not shut- down the power of the AV receiver while update.

■Universal Port

`via NET:

You can update the firmware via Internet. Check the network connection before update.

`via USB:

You can update the firmware from a USB mass stor- age device.

You can update the Onkyo dock’s firmware. Do not shut- down the power of the AV receiver while update.

Note

•This update shall not be performed when no dock is connected to UNIVERSAL PORT jack.

Lock Setup

With this preference, you can protect your settings by locking the setup menus.

Main menu Lock Setup

■Setup

`Locked:

Setup menus locked.

`Unlocked:

Setup menus not locked.

When the setup menus are locked, you cannot change any setting.

Using the Audio Settings

You can change various audio settings from the Home menu (➔ 26).

1	Press RECEIVER followed by HOME.
2	Useq/wto select “Audio”, and then use q/w/e/r
	to make the desired selection.

Note

•These settings are disabled when:

–a pair of headphones is connected, or

–the “Audio TV Out” setting is set to “On” (➔ 56) and an input selector other than HDMI is selected.

Tone Control Settings

You can adjust the bass and treble for the front speakers, except when the Direct, Pure Audio or THX listening mode is selected.

■Bass

`–10dBto 0dB to +10dB in 2 dB steps.

You can boost or cut low-frequency sounds output by the front speakers.

■Treble

`–10dBto 0dB to +10dB in 2 dB steps.

You can boost or cut high-frequency sounds output by the front speakers.

Operating on the AV receiver

1	Press TONE on the AV receiver repeatedly to
	select either “Bass” or “Treble”.
2	Use Up rand Down eon the AV receiver to
	adjust.

Note

•This setting is not available when the multichannel Analog input is selected.

Speaker Levels

You can adjust the volume of each speaker while listening to an input source.

These temporary adjustments are cancelled when the AV receiver is set to Standby. To save the setting you made here, go to “Level Calibration” (➔ 47) before setting the AV receiver to Standby.

■Subwoofer Level

`–15.0dBto 0.0dB to +12.0dB in 1 dB steps.

■Center Level

`–12.0dBto 0.0dB to +12.0dB in 1 dB steps.

Note

•You cannot use this function while the AV receiver is muted.

•Speakers that are set to “No” or “None” in the “Speaker Configuration” (➔ 46) cannot be adjusted.

Audyssey Settings

■Dynamic EQ

See “Dynamic EQ” of “Source Setup” (➔ 50).

■Dynamic Volume

See “Dynamic Volume” of “Source Setup” (➔ 51).

En

58