The single-35mm
carrier
1Open the 4x5 carrier as described previously.
2Locate the
3Orient the adapter so the metal tabs face up, and the notches are at the left edge. Slide the film into the channel, under the two metal tabs. Position the film so the image is
4If the film is unmounted or the mount is thin, use the slide spacer provided. Position the slide spacer underneath the slide (picture 14). The film should fit snugly into the adapter. (The spacer also ensures that the image will be at the correct dis- tance from the scanning mechanism.)
13 | 14 |
5Place the adapter in the 4x5 carrier, sliding the notches into the pins on the left edge. The slide and tabs should be facing up (picture 15).
6Close the carrier. Squeeze the carrier at the bottom edge and turn the knob to lock it (picture 16).
15 | 16 |
Setup and use |