Polaroid SprintScan 45 manual Setup and use

Page 16

The second port (25-pin) can be used to connect another SCSI device to the chain, using another SCSI cable.

3Terminate the signal at the last device in the chain. If the scan- ner is the last device, connect the terminator provided to the 50-pin port. Then connect the SCSI cable to the terminator (picture 3). Be certain to use only SCSI-specified cables for all connections in the chain. For details, see pages 2-8–2-9.

3

The diagrams on the following pages will serve as a reference to correct SCSI connections for various system configurations.

4Change the SCSI address of the scanner, if necessary, by press- ing the button marked (-) or (+) above and below the switch; see page 2-5 for details.

Setup and use

2-7

Image 16

Contents Page Table of contents Appendix a Specifications Index Quick Scanning Guide N t ro d u c t i o n Scanning modes System re q u i re m e n t s Technical Support Registration cardP a c k i n g Setup and use Scanner and accessoriesRear panel Positioning the scanner Scsi guidelinesPower OFF on the SCANNER, the Computer Scsi ID numbers ID number 7. The Macintosh internal hard drive usually usesInstalling a Scsi adapter in a PC Connecting the scanner to your computerSetup and use Diagrams of various Scsi configurations Tu rning on the scanner Using the film carr i e r s Setup and use 120 film adapters For 2 1/4 x 2 1/4 4 x 2 3/4 in. film Single-35mm Carrier S e rting the carrier into the scanner Removing the carr i e rA re and maintenance I n t e n a n c eTro u b l e s h o o t i n g Limited One Year Equipment Warranty ServiceL a roid Offices and Service Centers Belgique/BelgiëNew Zealand Radio and television interference Appendix a Specifications 40W D e Scsi