Polaroid SprintScan 45 manual Tu rning on the scanner

Page 18

Scanner and another

unterminated device

Place the scanner at the end of the chain and use the termina- tor provided. Do not add any additional terminators. If one external device has an internal terminator, see the previous example. Use only approved SCSI cables.

Tu rning on the scanner

1With the scanner off, plug the power cord provided into the scanner (picture 4), and then into an appropriate grounded outlet. The scanner can operate over a voltage range from 100 to 240 VAC.

2Turn on the scanner; the switch is next to the power connector. The POWER indicator light on the front of the unit will light, the cold cathode lamp will come on (visible through the slit on the top of the unit), and the READY indica- tor will flash briefly. The scanner will perform a self-test that lasts for a few seconds. If no problems are detected, the READY light will stay lit. The cold cathode lamp will also stay on.

3Once the ready light is lit, turn on your computer.

4

Setup and use

2-9

Image 18
Contents Page Table of contents Appendix a Specifications Index Quick Scanning Guide N t ro d u c t i o n Scanning modes System re q u i re m e n t s Technical Support Registration cardP a c k i n g Setup and use Scanner and accessoriesRear panel Positioning the scanner Scsi guidelinesPower OFF on the SCANNER, the Computer Scsi ID numbers ID number 7. The Macintosh internal hard drive usually usesInstalling a Scsi adapter in a PC Connecting the scanner to your computerSetup and use Diagrams of various Scsi configurations Tu rning on the scanner Using the film carr i e r s Setup and use 120 film adapters For 2 1/4 x 2 1/4 4 x 2 3/4 in. film Single-35mm Carrier S e rting the carrier into the scanner Removing the carr i e rA re and maintenance I n t e n a n c eTro u b l e s h o o t i n g Limited One Year Equipment Warranty ServiceL a roid Offices and Service Centers Belgique/BelgiëNew Zealand Radio and television interference Appendix a Specifications 40W D e Scsi