Nokia T66520, MW1122 user manual Step-by-step installation procedure

MW1122 User Manual

STA RED

Off	OK
On	Hardware malfunction during startup.
PWR	GREEN
Off	Power off.
On	Power on.

2.3Step-by-step installation procedure

1.Plug the mains power cord to a mains outlet.

2.Plug the antenna into the antenna connector of the wireless LAN card, if included.

3.Insert the wireless LAN card, if included, gently into the MW1122 WLAN slot on the MW1122 back panel. Ensure that the card is aligned correctly.

4.Switch on MW1122. The PWR indicator lights up.

5.Ensure that wireless LAN clients (that is, the wireless devices you want to use in your network) have the same configuration as the wireless LAN card in the MW1122 modem and that they are in the Infrastructure mode. The default wireless LAN configuration of MW1122 is the following:

regulatory-domain	according to your location of use (Europe,
	Canada, USA, or Japan)
network name	MW-wxyz (case-sensitive), where wxyz are
	the last four numbers from your MW1122
	serial number

When you have set the network name to your wireless client, the wireless connection is established and the WLAN indicator on MW1122 fron panel will be lit.

6.Connect the 8-pin Ethernet cable between your PC and the Ethernet connector on the MW1122 back panel if you want use a PC equipped with a 10Base-T Ethernet card. Switch on your PC. The ETH indicator will be lit.

4 E Copyright Nokia Networks Oy C33902002SE_00