Planar LB2650W manual Connecting the display Figure

Page 8

Connecting the display (Figure 1.1)

To set up this display, please refer to the following figure and procedures.

1.Be sure all equipment is off.

2.Connect the AC power cord to the power connector. Plug the other end into an electrical outlet(1).

3.For the PC with Analog graphics output: connect the VGA signal cable from display VGA input connector to the 15-pin connector of your host computer and tighten the screws(2).

4.For DVI or HDMI output: connect DVI cable from display to the PC.

5.Turn on your computer, display and video source.

Notice: To ensure the LCD display works well with your computer, configure the display mode of your graphic card, less than or equal to 1920 x 1200 resolution and make sure the timing of the display mode is compatible with the LCD panel. “Video Modes” of this LCD panel are listed in the appendices for your reference.

8

LB2650W User’s Guide (020-0973-00 Rev. A)

Page 7 Page 9
Image 8
Page 7 Page 9
Contents USER’S Guide Revision Control Table of Contents Precautions Usage NoticeIntroduction About Planar’s LB2650WHdmi to DVI Signal Cables Package OverviewInstallation & Dimensional Drawings Product OverviewConnecting the display Figure DVI-HDMI User Controls Front Panel ControlsHow to Use the OSD Menus Adjusting the Monitor’s Display OSD Function MenuFunction Description 14 LB2650W User’s Guide 020-0973-00 Rev. a No Signal 16 LB2650W User’s Guide 020-0973-00 Rev. a Press Exit Key + Menu Key + Soft power key at same time OSD Lock Out FunctionTroubleshooting AppendixStandard Timing Table Width20 LB2650W User’s Guide 020-0973-00 Rev. a Support and Service Americas SupportPlanar Systems, Inc. Customer Service
Top Page Image Contents