Planar LC1200R DC Power Input Requirements, DC Power Input Lines, DC Input Voltage / Current

Page 16

Pulse

 

 

 

 

Vertical Front

 

 

 

 

Porch

0.381 ms 12 lines

0.318 ms 10 lines

0.770 ms 37 lines

0.053 ms 3 lines

Vertical Back

 

 

 

 

Porch

1.112 ms 35 lines

1.049 ms 33 lines

0.478 ms 23 lines

0.514 ms 29 lines

Vertical Active

12.711 ms 400

15.254 ms 480

12.480 ms 600

13.599 ms 768

Display

lines

lines

lines

lines

Vertical Sync

 

 

 

 

Polarity

-

-

-

-

Note: VGA border is not included in the active display time described above.

Note: For video mode 720 x 400 missing video rows and columns are allowed. This is a text mode only. Performance is acceptable if characters as defined section 1.2.1 are legible. Missing row or columns at the edge of the display is acceptable as long as characters remain legible.

5 DC Power Input Requirements

5.1DC Power Input Lines

The DC Power Input Connector consists of two (2) positions wired numerically and supplied attached to the LC1200R as a chassis mounted connector per definitions listed in Table 7.

Table 7. DC Power Input Connector- Pin Assignments

PIN NUMBER

SIGNAL NAME

1Positive Input Voltage (12V)

2 Return (GND)

The DC Power Input Connector is a 2 pin Molex Mini Fit Jr. Pin number assignments are defined in Table 7; shown below is the physical layout as seen by the interface cable from the DC power source.

Figure 5

5.2DC Input Voltage / Current

DC Input Voltage: 12 V DC nominal, +/- .4 V DC.

Over the specified input voltage range:

No loss of image synchronization occurs.

White display luminance level is within 10% of luminance at nominal input voltage.

DC Input Current: 4.3 amp maximum current draw (12.4-vdc applied) steady state conditions.

LC1200R User’s Guide 021-0183-00 Rev A

16 of 29

Image 16
Contents LC1200R High-Bright Monitor DC Power Input Requirements Display Cosmetics LCD Panel Physical Image Characteristics IntroductionBasic Construction LCD DisplayDisplay format WeightMechanical Front View Video Signal Connector DC Power Input ConnectorPhotodiode Connector Dimming Control ConnectorPower Supply LCD Controller BoardInverter Board Photodiode BoardEnvironmental Temperature and HumidityButton Board Shock VibrationShock Packaged Product Video Signal Requirements Signal FunctionsVideo Input Lines Video ParametersSynchronization TTL Allowable Signal Levels Mode Detection TTL Sync Pulse Signal LevelsColor Display Detection Rise and Fall TimesTiming and Frequency Video Signal On-Off SequencesVideo, Horizontal and Vertical Sync DC Power Input Lines DC Power Input RequirementsDC Input Voltage / Current User Controls Power On-Off SequencesLCD Controller Board Controls User Adjustments Flip and MirrorMax Bright Jumper Dimming Control Connector Pin Assignment and Performance Photodiode Board and Automatic Dimming ConnectorAutomatic Brightness Mode Manual Brightness Mode Typical monitor brightness vs. ambient is as followsMaximum Brightness Mode Monitor PerformanceDIM input, volts Monitor LuminanceDisplay View Angle Display UniformityDisplay Chromaticity Color Perceived ColorDisplay Cosmetics Regulatory Agency RequirementsRFI Emission Certification System Transient Disturbance RequirementsElectrostatic Discharge Electromagnetic Energy Susceptibility RequirementsDescription of Warranty ReliabilityRohs Compliance Design WorkloadSupport and Service Glossary of Terms LC1200R User’s Guide 021-0183-00 Rev a