Planar LC1200R user manual Environmental, Button Board, Temperature and Humidity

Page 9

2.11 Button Board

The button board controls the user controls noted in Section 6.1 LCD Controller Board Controls It can be removed or mounted in another area after initial adjustments are made.

3 Environmental

3.1Temperature and Humidity

The LC1200R withstands operating and storage environmental conditions listed in Table 2.

Table 2

 

General Operating

Shipping and Storage

Comments

 

 

 

 

Temperature

0°C to 60°C

-20°C to 60°C

Note 2,3,4,5

 

[32°F to 140°F]

[-4°F to 140°F]

 

Relative

Note 1

Note 1

Without

Humidity

 

 

Condensation

Tair is defined as ambient air temperature surrounding the LC1200R.

Note 1:

Tair <

32°C

: 95% RH maximum.

 

Tair >

32°C

: Absolute humidity content not to exceed 100% at 32oC.

Note 2:

Tair @

-20°C

< 48 hours

 

Tair @

60°C

< 168 hours

Note 3: Slight background color changes are allowed depending on ambient temperature. This phenomenon is reversible.

Note 4: High temperature operation assumes the use of an enclosure that properly directs the fan airflow

Note 5: Upper operating temperature limit of 60°C is without solar loading.

Reference to "room ambient" is interpreted as 20°C - 25°C [68°F°-77°F] and applies throughout this specification unless otherwise noted.

For product reliability predictions, the assumed temperature profile is:

Table 3

Operating Time

Temperature

 

 

5%

0°C [32°F]

 

 

90%

30°C [86°F]

 

 

5%

60°C [140°F]

 

 

LC1200R User’s Guide 021-0183-00 Rev A

9 of 29

Image 9
Contents LC1200R High-Bright Monitor DC Power Input Requirements Display Cosmetics Introduction LCD Panel Physical Image CharacteristicsBasic Construction LCD DisplayWeight Display formatMechanical Front View DC Power Input Connector Video Signal ConnectorPhotodiode Connector Dimming Control ConnectorLCD Controller Board Power SupplyInverter Board Photodiode BoardTemperature and Humidity EnvironmentalButton Board Vibration ShockShock Packaged Product Signal Functions Video Signal RequirementsVideo Input Lines Video ParametersSynchronization TTL Allowable Signal Levels TTL Sync Pulse Signal Levels Mode DetectionColor Display Detection Rise and Fall TimesVideo Signal On-Off Sequences Timing and FrequencyVideo, Horizontal and Vertical Sync DC Power Input Requirements DC Power Input LinesDC Input Voltage / Current Power On-Off Sequences User ControlsLCD Controller Board Controls Flip and Mirror User AdjustmentsMax Bright Jumper Photodiode Board and Automatic Dimming Connector Dimming Control Connector Pin Assignment and PerformanceAutomatic Brightness Mode Typical monitor brightness vs. ambient is as follows Manual Brightness ModeMonitor Performance Maximum Brightness ModeDIM input, volts Monitor LuminanceDisplay Uniformity Display View AngleDisplay Chromaticity Color Perceived ColorRegulatory Agency Requirements Display CosmeticsSystem Transient Disturbance Requirements RFI Emission CertificationElectrostatic Discharge Electromagnetic Energy Susceptibility RequirementsReliability Description of WarrantyRohs Compliance Design WorkloadSupport and Service Glossary of Terms LC1200R User’s Guide 021-0183-00 Rev a