Planar LC1200R user manual User Adjustments, Flip and Mirror

Page 18

The Gain adjustment is to allow the full scale of the input video to be utilized. The direction of this adjustment will reverse when a limit is reached. For example, it will adjust from maximum to minimum, then reverse and go from minimum to maximum. The best way to make this adjustment is with a continuous gray scale pattern on the display. A proper adjustment will give continuous shading from black to white.

Auto Adjust: All four parameters (clock, Horizontal position, Vertical position, and gain) can be adjusted automatically by pressing the Horz and DotClk+ button simultaneously. The LC1200R will sense the incoming video and optimize its settings. For best results, display a pattern containing white and black with some white pixels along all four edges while the auto adjust is performed.

6.2User Adjustments

There are features that allow the user to adjust the properties of the LC1200R. These adjustments will require access to the video board PCB and the inverter. Access to the Photodiode Connector Section 2.5.3 and Dimming Control Connector Section 2.5.4 can be gained by removing 1 screw and a small access panel. See Figure 6. ESD precautions should be taken when removing this panel or the back cover of the unit.

Figure 6:

Remove Screw and

Door

6.2.1 Flip and Mirror

The unit has the capability to flip and/or mirror the video image. This can be done to allow for the power and video connector to be located on the other side of the unit for flexibility in mounting the LC1200R. Jumpers are located on the LCD Video Controller Board. See Figure

7 for jumper locations. Note the viewing angle in asymmetric. Rotating the display 180° will affect the apparent view angle. See Section 7 for view angle.

LC1200R User’s Guide 021-0183-00 Rev A

18 of 29

Image 18
Contents LC1200R High-Bright Monitor DC Power Input Requirements Display Cosmetics Basic Construction LCD Panel Physical Image CharacteristicsIntroduction LCD DisplayWeight Display formatMechanical Front View Photodiode Connector Video Signal ConnectorDC Power Input Connector Dimming Control ConnectorInverter Board Power SupplyLCD Controller Board Photodiode BoardTemperature and Humidity EnvironmentalButton Board Vibration ShockShock Packaged Product Video Input Lines Video Signal RequirementsSignal Functions Video ParametersSynchronization TTL Allowable Signal Levels Color Display Detection Mode DetectionTTL Sync Pulse Signal Levels Rise and Fall TimesVideo Signal On-Off Sequences Timing and FrequencyVideo, Horizontal and Vertical Sync DC Power Input Requirements DC Power Input LinesDC Input Voltage / Current Power On-Off Sequences User ControlsLCD Controller Board Controls User Adjustments Flip and MirrorMax Bright Jumper Photodiode Board and Automatic Dimming Connector Dimming Control Connector Pin Assignment and PerformanceAutomatic Brightness Mode Manual Brightness Mode Typical monitor brightness vs. ambient is as followsDIM input, volts Maximum Brightness ModeMonitor Performance Monitor LuminanceDisplay Chromaticity Display View AngleDisplay Uniformity Color Perceived ColorDisplay Cosmetics Regulatory Agency RequirementsElectrostatic Discharge RFI Emission CertificationSystem Transient Disturbance Requirements Electromagnetic Energy Susceptibility RequirementsRohs Compliance Description of WarrantyReliability Design WorkloadSupport and Service Glossary of Terms LC1200R User’s Guide 021-0183-00 Rev a