Planar LC1200R user manual Display format, Weight, Mechanical

Page 5

2.1.2 Display format

The LC1200R is compatible with IBM VGA1 and VESA2 video standards. Its operating frequency range is 31.5 kHz to 56.5 kHz horizontal; 60 Hz to 72 Hz (non-interlaced) vertical. Specific video resolutions supported in Table 1

Table 1

Video Resolution

Number of Bits/Color

Number of Colors

 

 

 

 

 

 

640 x 400

6

262,144

 

 

 

640 x 480

6

262,144

 

 

 

720 x 400

6

262,144

 

 

 

800 x 600

6

262,144

 

 

 

1024 x 768

6

262,144

 

 

 

For IBM VGA1 modes, the LC1200R will accept 640 pixels horizontally; 400 or 480 lines vertically and 800 pixels or 1024 pixels horizontally, 600 lines or 768 lines vertically for the VESA2 modes. Figure 4 defines the video signal timing requirements.

The LCD controller board will automatically program itself, sensing incoming horizontal/vertical frequencies and sync pulse polarities to completely “fill” the active display area of the LC1200R with the video resolution being presented. Section 4.2 defines parameters for video resolution detection by the LCD controller board.

Note: IBM VGA1 modes with border and the 720 x 400 video resolutions are excluded from completely filling the active display area horizontally. Only the first 640 pixels will be displayed.

2.2Weight

The LC1200R has a lightweight aluminum enclosure and does not exceed 1.8 kg (4 lbs)

2.3Mechanical

Size: 301mm x 265mm x 63 mm (11.9” x 10.4” x 2.5”)

See Planar Mechanical Outline drawing 076-0549-00 for more detail

Figure 1. View of Display

1IBM VGA is a registered trademark of International Business Machines Corporation

2 VESA is a registered trademark of Video Electronics Standards Association.

LC1200R User’s Guide 021-0183-00 Rev A

5 of 29

Image 5
Contents LC1200R High-Bright Monitor DC Power Input Requirements Display Cosmetics Introduction LCD Panel Physical Image CharacteristicsBasic Construction LCD DisplayMechanical WeightDisplay format Front View DC Power Input Connector Video Signal ConnectorPhotodiode Connector Dimming Control ConnectorLCD Controller Board Power SupplyInverter Board Photodiode BoardButton Board Temperature and HumidityEnvironmental Shock Packaged Product VibrationShock Signal Functions Video Signal RequirementsVideo Input Lines Video ParametersSynchronization TTL Allowable Signal Levels TTL Sync Pulse Signal Levels Mode DetectionColor Display Detection Rise and Fall TimesVideo, Horizontal and Vertical Sync Video Signal On-Off SequencesTiming and Frequency DC Input Voltage / Current DC Power Input RequirementsDC Power Input Lines LCD Controller Board Controls Power On-Off SequencesUser Controls Flip and Mirror User AdjustmentsMax Bright Jumper Automatic Brightness Mode Photodiode Board and Automatic Dimming ConnectorDimming Control Connector Pin Assignment and Performance Typical monitor brightness vs. ambient is as follows Manual Brightness ModeMonitor Performance Maximum Brightness ModeDIM input, volts Monitor LuminanceDisplay Uniformity Display View AngleDisplay Chromaticity Color Perceived ColorRegulatory Agency Requirements Display CosmeticsSystem Transient Disturbance Requirements RFI Emission CertificationElectrostatic Discharge Electromagnetic Energy Susceptibility RequirementsReliability Description of WarrantyRohs Compliance Design WorkloadSupport and Service Glossary of Terms LC1200R User’s Guide 021-0183-00 Rev a