Sharp AR-5316 X, AR-5320 X operation manual Changing A Tray’S Paper Size Setting, Envelopes

BEFORE USING THE MACHINE

Envelopes

Do not use the following envelopes, as misfeeds will occur.

•Envelopes with metal tabs, clasps, strings, holes, or windows.

•Envelopes with rough fibres, carbon paper, or glossy surfaces.

•Envelopes with two or more flaps.

•Envelopes with tape, film, or paper attached to the flap.

•Envelopes with a fold in the flap.

•Envelopes with glue on the flap to be moistened for sealing.

•Envelopes with labels or stamps.

•Envelopes that are slightly inflated with air.

•Envelopes with glue protruding from the seal area.

•Envelopes with part of the seal area peeled off.

CHANGING A TRAY’S PAPER SIZE SETTING

Follow these steps to change a tray’s paper size setting.

•	The paper size setting cannot be changed when the machine has stopped temporarily due to running out of
Note	paper or a misfeed, or during interrupt copying.

•During printing (even in copy mode), the paper size setting cannot be changed.

•A5 (5-1/2" x 8-1/2") size paper can only be selected in upper paper tray.

•Do not load paper that is a different size than the paper size setting. Copying will not be possible.

1 Hold down the [PAPER SIZE ENTER] key () for more than 5 seconds to set the selected paper size.

	The currently selected
	paper feed location
A3	indicator will blink and the
A4	corresponding paper size
A4
A5	(which is currently set)
B4

XTRA

indicator will light steadily. All other indicators will go out.

3 Use the [ORIGINAL SIZE ENTER] key (ENTER ) to select the paper size.

		The indicator of the
		selected paper size lights
	A3	up.
ENTER	A4
	A4
	A5
	B4
	TRA

2 If the machine has two paper trays, use the [TRAY SELECT] key () to select the paper tray for which you wish to change the paper size setting.

Each time the [TRAY SELECT] key () is pressed, a paper tray will be indicated with a blinking paper feed location indicator.

16