Mitsumi electronic XD3500U user manual Preparing your projector, Checking accessories

Preparing your projector

Checking accessories

The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in the package.

Cables

Mini D-SUB

15-pin

Mini D-SUB

15-pin

RGB cable for PC (J2552-0072-03)

D-SUB 9-pin

D-SUB 9-pin

RS-232C cable (J2552-0114-00)

•Used for projector control by computer.

Power supply parts

Power cord for US (J2552-0063-00) Power cord for EU (J2552-0066-00) Power cord for UK (J2552-0065-00)

Remote control parts

Remote control	R6 (size-AA)
(290P176-10)	battery (two)

Others

•Lens cap (attached to the projector)

•Terminal cover

•Lamp replacement tray

•CD-ROM

•Safety Manual/Quick Start up

Important:

• The attached power cords are to be used exclusively for this product. Never use them for other products.

Inserting the batteries into the remote control

1	1.	Remove the rear lid of the remote control.
	2.	Check the polarity (+), (-) of the batteries, and set them
	3	correctly, inserting their (-) side first.
		• If the battery is inserted from the (+) side first, inserting
		the (-) side is difficult because the coil spring end hits
		on the battery side. If the battery is forced to insert in
	2	this way, the outer label of the battery may get ripped
		and it may cause a short-circuit and heating.
	3.	Attach the rear lid.
	Important:
	•	Use two size-AA batteries (R6).
	•	Replace the 2 batteries with new ones when the remote
		control is slow to operate.

Removing the batteries from the remote control Remove the back lid of the remote control and take out the batteries.

Caution:

•Use of a battery of wrong type may cause explosion.

•Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

•Dispose of used batteries according to your local regulations.

•Batteries may explode if misused. Do not recharge, disassemble, or dispose of them in fire.

•Be sure to handle the batteries according to the instructions.

•Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.

•Keep batteries out of reach of children and pets.

•Remove the batteries, if the remote control is not used for a long time.

•Do not combine a new battery with an old one.

•If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.

EN-6