Mitsumi electronic XD3500U Viewing video images, Connecting the projector to video equipment

Viewing video images

A. Connecting the projector to video equipment

Preparation:

• Make sure that the power of the projector and that of the video equipment are turned off.

Connecting to a video player, etc.

		Video player, or the like
		To video	To audio
		output	output
		terminal 2	terminals
	To VIDEO	1 Video cable	4
	IN terminal	(option)	Audio cable
			(option)
	To audio	3
	input
	terminals
S-video cable (option)		Video player, or the like
	To S-video
1To S-VIDEO	output
	terminal 2 To audio
IN terminal		output

terminals

4

1.Connect one end of a commercially available video cable to the VIDEO IN terminal of the projector.

2.Connect the other end of the video cable to the video output terminal of the video equipment.

3.Connect one end of a commercially available audio cable to the audio input terminals (L/MONO, R) of the projector.

4.Connect the other end of the audio cable to the audio output terminals (L, R) of the video equipment.

When the video equipment is equipped with the S-video output terminal, make the connection as follows:

1.	Connect one end of a commercially available S-video cable
	to the S-VIDEO IN terminal of the projector.
2.	Connect the other end of the S-video cable to the S-video
	output terminal of the video equipment.
3.	Connect one end of a commercially available audio cable

To audio input 3 terminals

To VIDEO IN terminal (BNC)

Audio cable (option)

Video player, or the like

To video output terminal

to the audio input terminals (L/MONO, R) of the projector.

4. Connect the other end of the audio cable to the audio

output terminals (L, R) of the video equipment.

When using the BNC connector: (For VIDEO input)

• When the video output terminal of the connected video
	equipment is BNC type, use the VIDEO IN terminal (BNC
	type).
•	Select VIDEO as the input source.
•	When using the VIDEO IN terminal (BNC type) and the

BNC cable (option)

VIDEO IN terminal (RCA type) at the same time, the video

signal input to the VIDEO IN terminal (RCA type) takes

priority.

Video player, or the like

To S-video (Y/C) output terminals

To S-VIDEO IN

(Y and C) terminals (BNC)

BNC cable (option)

When using the BNC connector: (For S-VIDEO input)

•When the video output terminals of the connected video equipment are BNC (Y/C) type, connect Y and C to the S- VIDEO IN (Y and C) terminals (BNC type) respectively.

•Select S-VIDEO as the input source.

•When using the S-VIDEO IN (Y and C) terminals (BNC type) and the S-VIDEO IN terminal (S type) at the same time, the video signal input to the S-VIDEO IN terminal (S type) takes priority.

•When connecting a monophonic video device, use the white (L) terminal to connect the audio cable. (The same audio signal is output from the channels L and R of the AUDIO OUT terminal.)

•Also read the instruction manual of the equipment to be connected.

•Contact your dealer for details of connection.

When a TV tuner or VCR is connected:

When you use this projector with a TV tuner or VCR connected, no image may appear or a message of “NO SIGNAL” may appear on the screen when you change the channel via any channel that is not being received. In such a case, set the channels of the TV tuner or VCR again. To avoid such symptom, use the TV tuner or VCR with its channel skip function (that is a function not to display channels that are not being received) enabled.

EN-19