Using the Remote Controller
Installing the Batteries
Note
• If the remote controller
doesn’t work reliably, try replacing the batteries.
• Don’t mix new and old batteries or different
types of batteries.
• If you intend not to use the remote controller for
a long time, remove the batteries to prevent damage from leak- age or corrosion.
•Remove expired batteries as soon as possible to prevent damage from leakage or corrosion.
Aiming the Remote Controller
To use the remote controller, point it at the AV receiver’s remote control sensor, as shown below.
Remote control sensor
AV receiver
Approx. 16 ft. (5 m)
Contents |
|
Introduction |
|
Important Safety Instructions | 2 |
Precautions | 3 |
Speaker Precautions | 4 |
Package Contents | 4 |
Features | 6 |
Front & Rear Panels | 7 |
Speaker Package | 9 |
Remote Controller | 10 |
About Home Theater | 11 |
Connections |
|
Connecting the AV Receiver | 12 |
Turning On & Basic Operations |
|
Turning On/Off the AV Receiver | 20 |
Basic Operations | 21 |
Listening to the Radio | 23 |
Recording | 25 |
Using the Listening Modes | 26 |
Advanced Operations |
|
Advanced Setup | 29 |
Controlling iPod & Other Components |
|
Controlling iPod | 38 |
Controlling Other Onkyo Components | 42 |
Others |
|
Troubleshooting | 45 |
Specifications | 49 |
About HDMI | 51 |
Using an | 52 |
To reset the AV receiver to its factory defaults, turn it on and, while holding down VCR/DVR, press ON/STANDBY (➔ 45).
En
5