Muting the AV Receiver
You can temporarily mute the output of the AV receiver.
Press RECEIVER followed by MUTING.
The output is muted and the MUTING indicator flashes on the display.
Tip
•To unmute, press MUTING again or adjust the volume.
•The Mute function is cancelled when the AV receiver is set to Standby.
Using the Sleep Timer
With the sleep timer, you can set the AV receiver to turn off automatically after a specified period.
Press RECEIVER followed by SLEEP repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes in 10 minute steps.
The SLEEP indicator lights on the display when the sleep timer has been set. The specified sleep time appears on the display for about 5 seconds, then the previous display reappears.
Tip
•If you need to cancel the sleep timer, press SLEEP repeatedly until the SLEEP indicator goes off.
•To check the time remaining until the AV receiver sleeps, press SLEEP. Note that if you press SLEEP while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.
Using Headphones
Connect a pair of stereo headphones with a stan- dard plug (1/4 inch or 6.3 mm) to the PHONES jack.
Note
•Always turn down the volume before connecting your head- phones.
•While the headphones plug is inserted in the PHONES jack, the speakers are turned off.
•When you connect a pair of headphones, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, or Direct.
•Only the Stereo, Direct and Mono listening modes can be used with headphones.
En
Changing the Input Display
When you connect an
This setting can be done only from the front panel.
1 Press TV/CD, GAME or VCR/DVR on the front panel so that “TV/CD”, “GAME” or “VCR/DVR” appears on the display.
2 Press and hold down TV/CD, GAME or VCR/DVR (about 3 seconds) to change the input display. Repeat this step to select “MD”, “CDR”, “DOCK” or “TAPE”.
For the TV/CD input selector, the input display changes in this order:
TV/CD → MD → CDR
→ | TAPE | → | DOCK |
|
| ||||
| → | |||
|
|
|
For the GAME input selector, the setting changes in this order:
GAME ↔ DOCK
For the VCR/DVR input selector, the setting changes in this order:
VCR/DVR ↔ DOCK
Note
•DOCK can be selected for the TV/CD, GAME or VCR/DVR input selector, but not at the same time.
•Enter the appropriate remote control code before using the remote controller for the first time (➔ 42).
Selecting Speakers A and B
You can use two sets of front speakers with the AV receiver: Speakers A for up to
Press RECEIVER followed by SP A/B repeatedly to cycle through the selection:
Speakers A → Speakers A&B → Speakers B
→ |
|
| |
|
| ||
|
|
|
|
|
| Off ← |
A or B, or both indicators light on the display.
Note
•While Speakers B is on, channels are reduced to 2.1 in the main room (➔ 11).
Tip
• Alternatively, you can use the AV receiver’s SPEAKERS A and B.
22