Garmin TR-1 owner manual Rudder Position Display, Rudder Calibration

Page 12

Rudder Position Display

The rudder position display is optional. If you wish to use this portion of the display, you will need to purchase an aftermarket transducer unit.

The rudder position display is activated by a mode selection from the handheld on the autopilot. A rudder position transducer must be installed and calibrated before this mode will work correctly. The rudder position is indicated by the bars at the bottom of the display. See Figure 19.

The rudder indicator must be calibrated before use.

Activating this mode will not prevent the use of the rate turn command, but the bars will indicate the rudder angle NOT the rate of turn.

Figure 19

Rudder Calibration

Before you start: You must orientate your rudder indicator or center the potentiometer according to the manufacturers instructions. This must me done before the calibration is started.

The rudder indicator must be calibrated before use. Follow these steps;

1.Center the rudder.

2.Enter autopilot setup by pressing and releasing the [SETUP] button on the handheld remote. Enter code 59 by Pressing and releasing the left Chevron Button on the handheld two (2) times

Page 11

Image 12
Contents TR-1 Gladiator Introduction Safety Installation of Basic LCD Display Tools requiredMulti-Mount Panel Installation Mounting the Display UnitConnecting the Display Wiring Connecting the Display With Wireless Remote Operating the Display LED Backlight ControlDisplay Elements Heading Command Display Rate of Turn Command Dial Rudder Position Display Rudder Calibration
Related manuals
Manual 53 pages 31.36 Kb Manual 48 pages 48.1 Kb