Garmin TR-1 manual Safety

Page 1

Safety

You are responsible for the safe and prudent operation of your vessel. Your TR-1 Autopilot is a tool that will enhance your capability to operate your boat and catch fish. It does not relieve you from the responsibility for safe operation of your vessel. You must avoid hazards to navigation and never leave the helm unattended.

In case of autopilot pump failure or leakage, shut the valves located on the front of the manifold see page 15.

Before starting the hydraulic installation, please verify the type of hydraulic steering in the boat. If it does not match the hydraulic layouts in this manual, call technical support for specific installation procedures.

NOTE:

Before proceeding with the installation, read these instructions thoroughly. TR-1 Autopilots cannot accept responsibility for installations where instructions have not been followed, where substitute parts have been used, or where modifications have been made to our products.

1

Image 1
Contents Safety Contents Ea. #14 x 1 Phillips Pan Head screw 310-0072-18 Pump Unit TR-1 Gladiator 2.1 Liter System Parts ListElectronic Control Unit Compass BallAccessory Pack TR-1 Gladiator System Parts ListSingle Helm Hydraulic Layout Dual Helm Hydraulic Layout Electrical Layout Section II Setup Gladiator Installation & SetupSection IV Setup Codes Battery Connections. See Installation Check ListPreparation For Installation TR-1 Gladiator SpecificationsProtection Magnetic Environment Installation Of Pump Unit Verify All Connections Prior to Applying power Installation Of Electronic Control Unit ECUKeep Separated Step Four Connection Installation of Compass BallNmea 0183 Connections Non-Compliant Nmea 0183 Devices Electrical Connections Installation Of Shadow Drive Valve Single Helm StationInstallation Of Shadow Drive Valve Dual Helm Station Compass Ball Horn Red + Orange + Installation Of Warning HornInstallation of On/Off Switch Using Waterproof Bezel Installation of Deckmount On/Off SwitchInstallation of On/Off Switch Using Standard Bezel Corded Mount Installation Of HandheldCorded Mount Flush Mount’s Gasoline Tachometry ConnectionsEvinrude E-Tech Bleeding Hydraulics Battery ConnectionsSection Dockside Setup and Sea Trial Setup of AutopilotStep D. Release Select Load button To start Compass calibrationChevron button two times, and light up #5 LED With The GPS Connected to Autopilot Set NorthFine Tuning. Optional Trouble Shooting Guide How to Change Parameters of Setup Codes Description Code Values of the Parameters Factory Defaults Table of Setup Codes and Values of the ParametersDescription Code Table of Setup Codes and ParametersTachometer Codes Model From GPS To Autopilot Nmea Out Manufacturer GPS Connection GuideFuruno GarminLowrance HummingbirdMagellan From GPS To Autopilot Nmea Out ManufacturerNorthStar RayMarineSimrad Section I Parts List Installation of Wireless RemoteSection III Installation SectionParts List Wireless Two Button Description Qty Qty Parts List Wireless Five Button DescriptionIntroduction SafetyThank You Keypad push-button functions Wireless Remote Functions, Two ButtonKeypad push-button functions Wireless Remote Functions, Five ButtonWireless Installation Installation ConsiderationsAntenna Installation Security Codes Replacement Remote KeypadsChanging Batteries Limited Warranty
Related manuals
Manual 13 pages 3.61 Kb Manual 53 pages 31.36 Kb