Installation Of Electronic Control Unit (ECU)
Electronic Control Unit (ECU): Mount the ECU using the template provided. Mount it to a solid surface using the four #8 x 5/8” Phillips Pan Head screws included in the accessory pack.
The ECU will need to be mounted within 20” of the pump unit. (Wire length only allows for 20” and cannot be lengthened) Most all components in the system connect to this unit, so considerations will need to be made due to cable access and lengths.
Do not use any grease inside the pico connections on the ECU, the plugs will not fit properly, and you will end up with a loose connection. Be sure to push the pico connectors firmly into place, and use wire ties to keep them from being pulled loose. There are several places on the ECU to tie them.
Do not splice or lengthen the #5 wire or the black and orange twisted wire from the pump motor
Verify All Connections Prior to Applying power!
Hydraulic Pump
& Motor
Keep Separated | # 5 |
|
Orange and Black Twisted Wire
Keep the orange and black twisted wires on the pump motor separated from the #5 wire coming from the pump motor as shown.
Place a tie wrap around the Anderson connectors as pictured above. It is important that this procedure is done; the tie wraps will keep the connectors from the possibility of coming apart due to vibration.
14