Garmin TR-1 manual Table of Setup Codes and Parameters, Description Code

Table of Setup Codes and Parameters

	FINE TUNING CODES
Description	Code	Values of the Parameters	Factory
			Defaults
Acceleration Limiter	5	1 lowest accel, 100 Highest accel	39

Code 5: This parameter limits the aggressiveness of the autopilot controlled turns. Turn it up to allow higher rate turns and down to limit the turn rate.

Seastate Filtering	1	1 least responsive steering, 4 most responsive	4
		steering

Code 1: Seastate adjustments, toward least responsive, slow the heading response down and reduce rudder activity. Most of the time you will want to run with this parameter all the way at the top of its range. In choppy or trailing seas at low speeds, reducing this parameter will save wear and tear on your system.

Low Speed Rudder Gain	27	1 lowest gain 97 highest gain	39
Low Speed Counter Rudder Gain	37	1 lowest gain, 97 highest gain	72
High Speed Rudder Gain	29	1 lowest gain 97 highest	39
High Speed Counter Rudder Gain	39	1 lowest gain, 97 highest gain	72
Following Seas Switch	159	[Up Arrow] on, [Down Arrow] off	off
Code 159: Turning this parameter on may increase stability in severe trailing seas.
Turn Stop Adjust	268	1 least adjustment, 40 most adjustment	1
Code 268: At planing speed and for large turn angles; if your boat tends to turn further than you programmed for, (like

50 degrees when you programmed 45 degrees) and then slowly recovers to the turn angle you expected, turning this parameter up may solve the problem.

		AUTOMATED SETUP CODES
Description	Code
Calibrate Compass	47	Hold Down [Select Load] Button, Press and Release Deckmount Button
		to Start Calibration Process
Autotune	58	Hold Down [Select Load] Button, Press and Release Deckmount Button
		to Start Tuning Process.
		Code 57: Code 57 lets you select an alternate autotune. You may want to try this
		if the normal tune didn’t work. After selecting the alternate by selecting code 57 and
		pressing the Down Arrow button (so that the Down Arrow LED is lit), go back to code
		58 to initiate the autotuner.
Load Factory Compass	247	Hold down [Select Load] button, Press and Release Deckmount Button
		to Reload Factory Pilot Settings
Load Factory Pilot	248	Hold Down [Select Load] Button, press and release Deckmount Button
		to Reload Factory Pilot Settings
Show Software Version	369	Hold Down [Select Load] Button, version=blink code/100

34