Garmin TR-1 owner manual Operating the Display, LED Backlight Control

Page 8

Operating the Display

Shows Current Heading

Steering

ModeSteer to a new Desired Heading

Rudder Angle

Backlit For Easy Night Vision

or Turn Rate

 

Directional Input Dial

Indicator

 

 

Setting your display for accurate heading output:

The heading display displays the current heading of the vessel. The compass must be calibrated and north set for this display to be correct. Please see your Gladiator’s Owner’s Manual for these instructions.

The heading on the display may not match your compass or your GPS. This is normal. Once the Gladiator system’s compass has been calibrated and north has been set, it may be the most accurate heading display on your boat.

LED Backlight Control

There is an LED backlight to be used in low light conditions. The backlight is activated and adjusted by pressing and holding the directional input dial for greater than 4 seconds. The backlight will cycle through six (6) separate intensities while the dial is being held down. Let up on the dial when the desired intensity is reached.

Page 7

Image 8
Contents TR-1 Gladiator Introduction Safety Installation of Basic LCD Display Tools requiredMulti-Mount Panel Installation Mounting the Display UnitConnecting the Display Wiring Connecting the Display With Wireless Remote Operating the Display LED Backlight ControlDisplay Elements Heading Command Display Rate of Turn Command Dial Rudder Position Display Rudder Calibration
Related manuals
Manual 53 pages 31.36 Kb Manual 48 pages 48.1 Kb