Settings menu

Audio: allows adjustments to the volume and mute, and turns the projec- tor’s startup Chime on and off.

Sources: allows you to assign a particular input to a specific source key on the remote. Also allows selection of a default Startup Source and enables or disables Autosource and RGB Video.

Sources>Startup Source: this determines which source the projector checks first for active video during power-up.

Sources>Autosource: When Autosource is not checked, the projector defaults to the source selected in Startup Source. If no source is found, a blank screen displays. When Autosource is checked, Startup Source deter- mines which source the projector defaults to at power-up. If no signal is present, the projector checks the sources in order until a source is found or

Audio

Startup

Source

until power down.

Sources>RGB Video: check this box if you are using a DVD player with RGB output.

System>Rear: reverses the image so you can project from behind a translu- cent screen.

Ceiling: turns the image upside down for ceiling-mounted projection.

Auto Ceiling: automatically senses when the projector is inverted and turns the image upside down. This is On by default.

Auto Power: When Auto Power is checked, the projector automatically goes into the startup state after the projector is powered on. This allows con- trol of ceiling mounted projectors with a wall power switch.

Display Messages: displays status messages (such as “Searching” or “Mute”) in the lower-left corner of the screen.

Power Save: automatically turns the lamp off after no signals are detected for 5 minutes. After 3 additional minutes with no signal, the projector pow- ers down. If an active signal is received before the projector powers down, the image will be displayed.

Screen Trigger: turns on the 12 volt DC output switch on the connector panel.

Backlight: allows you to turn off the backlighting on the keypad.

Sources

System menu

Screen Save