Replacing the projection lamp
The lamp hour timer in the About menu counts the number of hours the lamp has been in use. When the lamp timer reaches the estimated total lamp life, the LED on the projector’s keypad blinks red (indicating a lamp error, see page 36) and a dialog box appears each time the projector is turned on. You can order new lamp modules from your dealer. See “Accessories” on page 35 for information.
1Turn off the projector and unplug the power cable.
2Wait 60 minutes to allow the projector to cool thoroughly.
3Turn the projector upside down and remove the lamp door by loosening the captive screw and then prying the lamp door out.
4Remove the two screws on the lamp module.
WARNINGS:
•To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp.
•Unplug the power cord before replacing the lamp.
•Do not drop the lamp module. The glass may shatter and cause injury.
•Do not touch the glass portion of the lamp module. Fingerprints can obscure projection sharpness.
About menu
turn off and unplug
Y Pb Pr |
| trigger |
| audio in | the projector |
serial control
wait 60 minutes
loosen the screw on lamp door | pry the lamp door off | ||
|
|
|
|
|
|
|
|
|
|
|
|
remove the screws on lamp module
32