•Be extremely careful when removing the lamp housing. In the unlikely event that the lamp ruptures, small glass fragments may be generated. The lamp module is designed to contain most of these fragments, but use caution when removing it. Before replacing the lamp, clean the lamp compartment and dispose of cleaning materials. Wash hands after lamp replacement. This product has a lamp which contains a very small amount of mercury. Dispose of it as required by local, state or fed- eral ordinances and regulations. For more information see www.eiae.org.
5Carefully remove the lamp module by grasping and lifting the metal bail wire. Dispose of the lamp in an environmentally proper manner.
6 | Install the new lamp module, making sure that it is properly seated. | remove module using bail wire |
|
7Replace the two screws.
8 Replace the lamp door and tighten the screw.
9Plug in the power cable then press the Power button to turn the projec- tor back on.
10Reset the lamp hour timer by navigating to the Settings>Service menu and selecting Lamp Reset.
reset lamp time in Service menu
33