Shutting down the projector
Screen Save Time
You can make the black screen appear after a preset number of minutes by turning on the Screen Save Time feature in the Setup menu. See page 29.
Auto Off Time
The projector has an Auto Off Time feature that automatically turns the projector off if no active sources are detected and no user interaction with the projector is performed for 30 minutes. By default, this feature is off. You can change the length of time, see page 29.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The lamp turns off and the LED blinks amber for 10 seconds while the fans continue to run to cool the lamp. When the lamp has cooled, the LED lights amber and the fans stop. Unplug the power cable to completely power off the projector.
Troubleshooting your setup
The Status Indicator Panel on top of the projector indicates the state of the projector and is a helpful when troubleshooting.
Table 3: Status indicator light behavior and meaning
Icon | Meaning | |
|
|
|
Power, solid amber | The projector is plugged in. | |
Power, blinking green | The power button has been pressed and | |
|
| the software is initializing. |
Power, solid green | The projector is on and initialized. | |
Power, blinking amber | The power button has been pressed to | |
|
| turn the projector off and the fans are |
|
| running to cool the projector. |
|
|
|
Temperature | The projector is too hot. Make sure the | |
|
| vents aren’t blocked (see page 20). Turn |
|
| the projector off and wait one minute, |
|
| |
|
| then turn the projector on again. Contact |
|
| Technical Support if the problem persists. |
|
| Visit www.infocus.com/support to contact |
|
| service. |
|
|
|
Lamp | Turn the projector off and wait one | |
|
| minute, then turn the projector on again. |
|
| If the lamp light turns on again, replace the |
|
| lamp and reset the lamp timer (page 42). |
|
|
|
Wrench/Service | Turn the projector off and wait one | |
|
| minute, then turn the projector on again. |
|
| If the service lamp turns on again, service |
|
| is required. Visit www.infocus.com/ |
|
| support to contact service. |
|
|
|
14