InFocus M2100 manual Important Operating Considerations for Safety

Page 4
Important Operating Considerations for Safety

Important Operating Considerations for Safety

Refer to this guide for proper startup and shutdown procedures.

Follow all warnings and cautions in this manual and on the projector.

Place the projector in a horizontal position no greater than 8 degrees off axis.

Locate the projector at least 4' (1.2m) away from any heating or cooling vents.

Do not block ventilation openings. Locate the projector in a well- ventilated area without obstructions to intake or exhaust vents. Do not place the projector on a tablecloth or other soft covering that may block the vents.

Do not place the projector in direct sunlight, humid, greasy or dusty places or in places where the projector may come into contact with smoke or steam.

Do not look directly into the lens while the projector is being used.

Do not drop the projector.

Do not spill liquid on the projector. Spilled liquid may damage the projector.

Use the power cord provided. Connect the power cord to a receptacle with a protective safety (earth) ground terminal. A surge-protected power strip is recommended.

Do not overload wall outlets.

When disconnecting the power cord, hold the plug, not the cord.

Wash hands after handling the cables supplied with this product.

The projector remote control uses batteries. Make sure the batteries’ polarity (+/-) is aligned correctly. Dispose of used batteries in accordance with local disposal laws.

Use an InFocus approved ceiling mount kit for proper fitting, ventilation and installation. The warranty does not cover any damage caused by use of non-approved ceiling mount kits or by installing in an improper location.

When the projector is ceiling mounted, wear protective eyewear to prevent eye injury before opening lamp door.

Refer all service to qualified service personnel. Servicing your own projector can be dangerous to you and will void the warranty.

Only use replacement parts specified by InFocus. Unauthorized substitutions may result in fire, electrical shock, or injury, and may void the warranty

Only genuine InFocus lamps are tested for use in this projector. Use of non InFocus lamps may cause electrical shock and fire, and may void the projector warranty.

Hg – Lamp contains mercury. Manage in accordance with local disposal laws. See www.lamprecycle.org.

The projector uses a high-pressure mercury glass lamp. The lamp may fail prematurely, or it may rupture with a popping sound if jolted, scratched, or handled while hot. The risk of lamp failure or rupture also increases as the lamp age increases; please replace the lamp when you see the “Replace Lamp” message.

In the unlikely event of a lamp rupture, particles may exit through the projector vents. Keep people, food, and drinks out of the "keep out" area under and around the projector, as indicated by the "X" areas below.

 

 

 

 

 

 

 

2’

 

 

 

 

 

 

 

/

 

 

 

 

 

 

 

0

 

 

 

 

 

 

 

.

 

 

 

 

 

 

 

6

 

 

 

 

 

 

 

m

8’

 

 

 

 

 

 

m

 

 

 

 

 

 

.

 

/

2

 

 

 

 

5

 

.4

 

 

1

 

 

m

/

 

 

 

 

 

 

 

 

 

 

 

 

5

 

 

Follow these instructions to help ensure image quality and lamp life over the life of the projector. Failure to follow these instructions may affect the warranty. For complete details of the warranty, see the Warranty Booklet.

3

Image 4
Contents IN2112, IN2114, IN2116 Regulatory models V2000, M2100Declaration of Conformity TrademarksFCC Warning CanadaTable of Contents Important Operating Considerations for Safety Product specifications Optional AccessoriesIntroduction Online registrationConnector panel 5 volt DC outputPositioning the projector Table 1 IN2112 SVGA and IN2114 XGARange of distance to the screen for a given screen size Table 2 IN2116 WXGACeiling Mount Connecting a computer source Connecting powerVGA connection Optional computer connections Connect audio cable Connect monitor cable Connect USB cableDisplaying an image No start up screen? Get help on pageAdjusting the image Connecting a video device Video device connectionsComposite video connection S-video connection43 screen What is Aspect Ratio?169 screen 43 mode 169 mode Native mode Troubleshooting your setup Table 3 Status indicator light behavior and meaningShutting down the projector Screen Save TimeProblem No start up screen SolutionPlug power cord into the projector then press power buttonProblem No computer image, just the words “Signal out of range”A A Only my laptop’s background appears, not thePanel Display Settings tab Move projector and adjust zoomImage fuzzy or cropped Image clear and not croppedProblem Image not square Image not sharp Adjust Keystone in the Basic Picture menuAdjust Sharpness in the Basic Picture menu Image does not fit 43 or 169 screenTurn off Ceiling Mount in Setup menu Turn off Rear Project in Setup menuAdjust color, tint, brightness, contrast in the Basic Image upside downStartup Screen Turn off the internal LCD display on your laptopEmbedded video plays correctly does not play on the screenwon’t turn on, Lamp light is turned on Top front coverReplace lamp Still need assistance?Using the remote control Troubleshooting the remoteUsing the audio Using the projector’s speakersConnecting external speakers Troubleshooting AudioPresentation features Using the keypad buttonsOptimizing computer images Customizing the projector Optimizing video imagesDynamic Messaging Using the menus Basic Picture menu Advanced Picture menu Setup menu Keypad Enable Enables or disables keypad Disable Snapshot Allows the user to disable the snapshot capabilityFast Color Refresh Controls color wheel speed To change the PIN To enter the PIN at projector startupIf you lose or forget your custom PIN Status and Service menu HelpBefore using the network functions Configuring and Controlling the Projector via a Web BrowserIf Using a Network with DHCP Enabled If Using a Network that Does Not have DHCP EnabledNavigating Projector Web Pages Network Settings Page administrators onlyProjector Controls Page All users Date/Time Settings Page administrators only Event Notifications Page administrators onlyScheduled Tasks Page administrators only Security Settings Page administrators only System Log Page administrators onlyNetwork Utilities Page administrators only Troubleshooting Network FunctionsUsing LitePort IN2114 & IN2116 only Using the LitePort MenuImage File Types Viewing a Slide ShowDisplaying PowerPoint Slides Troubleshooting LitePort Cleaning the lens MaintenanceWARNINGS Turn off and Replacing the projection lampunplug projector Using the security lock Numerics INDEXU USB Viewing a Slide Show 37 Volume button W warranty zoom