M a i n t e n a n c e | & | T r o u b l e s h o o t i n g |
|
|
|
8Align the new lamp module in the correct direction.
9Gently push the module in as far as it goes.
10Tighten the screws on the outside of the module.
11Slide the lamp connector to the left to
12Insert the tabs at the top of the lamp door into the projector and press the lamp door into place.
13Plug in the power cord and turn the projector back on.
14To reset the lamp hour counter in the Status window, press and hold the left mouse button, then press the menu button (while still holding down the mouse button) for 5 seconds.
Verify that the counter was reset by pressing the menu button and viewing the counter in the Status window.
Replacing the Batteries in the Remote Control
The life of the batteries depends on how often and how long you use the remote. Symptoms of low battery charge include erratic responses when using the remote and a reduced range of opera- tion.
Follow these steps to replace the batteries:
1Turn the remote face down in your hand.
2Slide the battery cover off the end of the remote by pressing on it with the heel of your hand.
3Remove the old batteries.
4Install two new AAA alkaline batteries. Make sure you install each in the correct direction.
5Slide the battery cover back on the remote.
38