Onkyo 29344934 instruction manual Changing the Input Display

First Time Setup—Continued

2	Use the Up and Down [q]/[w]
	buttons to select “2.Digital

Audio”, and then press [ENTER].

3	Use the Up and Down [q]/[w]
	buttons to select an input
	selector, and then use the Left
	and Right [e]/[r] buttons to
	select:
	COAX1: Select if the component is
		connected to DIGITAL IN
		COAXIAL 1.
	COAX2: Select if the component is
		connected to DIGITAL IN
		COAXIAL 2.
	OPT1:	Select if the component is
		connected to DIGITAL IN
		OPTICAL 1.
	OPT2:	Select if the component is
		connected to DIGITAL IN
		OPTICAL 2.
	- - - - -:	Select if the component is
		connected to an analog input.

4	Press the [SETUP] button.
	Setup closes.

Notes:

•Make sure you also set your digital sources to send out a digital signals. Please refer to the digital sources’ manual.

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

Changing the Input Display

If you connect an u-capable Onkyo MiniDisc recorder, CD recorder, or RI Dock to the TV/TAPE IN/OUT jacks, or connect an RI Dock to the CBL/SAT IN or VCR/DVR IN jacks, for uto work properly, you must change this setting.

This setting can only be changed on the AV receiver.

CBL/SAT TV/TAPE

VCR/DVR

1	Press the [TV/TAPE], [CBL/SAT]
	or [VCR/DVR] input selector
	button so that “TV/TAPE”,
	“CBL/SAT” or “VCR/DVR”
	appears on the display.
	or

or

2	Press and hold down the
	[TV/TAPE], [CBL/SAT] or
	[VCR/DVR] input selector button
	(about 3 seconds) to change the
	setting.
	Repeat this step to select MD, CDR, or
or	DOCK.
	For the TV/TAPE input selector, the
	setting changes in this order:
	TV/TAPE → MD → CDR
or	→	DOCK	→

For the CBL/SAT input selector, the setting changes in this order:

CBL/SAT ↔ DOCK

For the VCR/DVR input selector, the setting changes in this order:

VCR/DVR ↔ DOCK

Note:

DOCK can be selected for the TV/TAPE or CBL/SAT or VCR/DVR input selector, but not at the same time.

43