Displaying an image
Connect the power cord to the Power connector on the back of the projector and to your electrical outlet.
NOTE: Always use the power cord that shipped with the projector.
Press the Power button on the remote or keypad.
The LED flashes green and the fans start to run. When the lamp comes on, the
?No start up screen? Get help on page 13. Plug in, connect, and turn on your video device.
The video device’s image should appear on the projection screen. If it doesn’t, press the Source button on the keypad until the image appears.
?No image? Try pressing the Auto Image button on the remote. Get help on page 13.
plug in Power cord
press Power button
turn on video device
Adjusting the image
Adjust the height of the image by tilting the projector up or down.
Position the projector the desired distance from the screen at a 90 degree angle to the screen.
See page 5 for a table listing screen sizes and distances to the screen.
adjust height
adjust distance
10