![](/images/new-backgrounds/1315135/31513531x1.webp)
Adjustments (continued)
!WARNING Disconnect plug from power source before performing any assembly,
adjustment or repair to avoid possible injury.
Blade Square to Fence
1.Slide saw forward so blade is near the center of the table and tighten slide rail lock knob.
2.Lower head assembly and engage head assem- bly lock pin.
3.Set table at the 0° miter position and tighten miter lock knob.
4.Place combination square against fence with ruler of square parallel to blade. Ruler should contact blade, but not blade teeth. If blade is not square against ruler, follow the fence alignment proce- dure. (Figure 1)
5.Loosen rail lock knob and slide head assembly back to check squareness of complete slide cut against the square’s ruler.
Fence Alignment
a.Remove both fences by loosen fence knob, slide fence to full in position, and pull up on fence.
b.The head assembly should remain in lowered position.
c.Loosen the four (4) hex bolts behind fence using multi purpose wrench (Figure 2).
d.Adjust fence until blade and fence have full con- tact with the square.
e.Tighten the four (4) hex bolts.
f.
Fence
Blade
Combination Square
Figure 1. Blade Square to Fence
Hex Fence
Fence HexBolts Knob
Knob Bolts
Figure 2. Fence Adjustment
Miter Scale
Indicator Adjustment
1.Set table at the 0° miter position and tighten miter lock knob.
2.Raise the head assembly to the
3.Loosen the Phillips screw that holds the indicator in place.
4.Position the indicator to align with the 0° miter mark and tighten the screw.
Indicator
Adjustment
Screw
|
|
|
|
|
|
| 0 | 85 |
|
|
|
|
|
|
| 85 |
|
| |
|
|
|
|
| 80 |
|
| 5 | |
55 |
|
| 70 | 75 |
|
|
| ||
60 | 65 |
|
|
| 0 | ||||
|
|
|
|
|
| ||||
|
|
|
|
|
|
| 5 |
| |
|
|
| .5 |
|
| 10 |
|
| |
| 31 |
|
|
|
|
|
| ||
|
| 22 |
|
|
|
|
| ||
| .6 |
| 20 | 15 |
|
|
|
| |
35 | 30 25 |
|
|
|
| ||||
|
|
|
|
| |||||
|
|
|
|
|
|
0° Mark
Miter Scale
Indicator
3 | 6 |
35 | 55 |
40 | 50 |
| 45 |
Figure: Miter Scale Adjustment
16.