Bosch Power Tools 4410L manual Miter Cut, Follow these instructions for making your miter cut

Miter Cut

•A “miter cut” is a cross-cut made with the blade ver- tical (non-tilted) at a horizontal angle relative to the fence.

•A miter cut is made at 0° bevel and any miter angle in the range from 52° left to 60° right.

•The miter scale shows the angle of the blade relative to the fence angle is cast-in on the table for easy reading.

•Positive detents have been provided for fast and accurate mitering at 0°, 15°, 22.5°, 31.6° and 45° left and right and 60° right.

•The crown molding detents (left and right) are at 31.6° (See Cutting Crown Molding for more infor- mation page 31).

•For precision settings at angles next to the detents, use the detent override to lock out the detent. This prevents the wedge on the detent lever from slipping back into the detent.

•A miter cut can be made as either a chop cut or a slide cut, depending on the width of the workpiece.

•The kerf inserts should be as close to the blade as possible without touching the blade (see Kerf Inserts for adjustment procedures).

Follow these instructions for making your miter cut:

1.Loosen miter lock knob. Lift miter detent lever and move the saw to the desired angle, using either the detents or the miter scale. Tighten miter lock knob.

2.Extend the base extensions and fence on the side on which the cut will be made. (See Sliding Fences and Base Extensions on page 25).

3.Properly position workpiece. Make sure workpiece is clamped firmly against the table or the fence.

Use clamping position that does not ! WARNING interfere with operation. Before

switching on, lower head assembly to make sure clamp clears guard and head assembly.

4. Follow procedures for either chop cut or slide cut (see page 26).

5. Wait until blade comes to a complete stop before returning head assembly to the raised position and/or removing workpiece.

Quick

Action

Clamp

Miter

Workpiece Scale Detents Miter Lock

Knob

Figure: Miter Cut

27.