Unpacking & Checking Contents
Before moving the saw: Lock the ! WARNING miter lock knob in 60° position. Lock
bevel lock handle. Pull the head assembly complete- ly toward you and tighten the slide rail lock knob. Lock head assembly in the down position.
Never carry the tool by the slide rails, this may cause blade damage. Never carry the tool by the cord or head assembly power switch handle. Damage to insulation could cause an electric shock. Damage to wire connections could cause a fire.
Your new Model 4410 Miter Saw is shipped complete in one box, But you may need to make some adjust- ments and alignments before cutting final work- pieces.
Separate all parts from packing materials and check each one with the “Check List of Loose Parts” to make sure all items are accounted for before dis- carding any packing material.
Check List of Loose Parts:
■Quick- Action Clamp (Item #25 on page 8)
■Dust Elbow/Dust Bag (Item #42 on page 9)
■Multi Purpose Tool (See below)
■Miter Lock Knob (Item #13 on page 8)
■1.5mm Hex “L” Wrench (See below)
■3mm Hex “L” Wrench (See below)
■10mm/17mm Combination
■Arbor Laser / 3x Battery / Arbor Laser Manual
!WARNING If any parts are missing, do not plug in power cord or turn the switch on
until the missing parts are obtained and are installed correctly.
Tools for Assembly & Alignment
(supplied, stored on the right rear base)
Combination Square (not included)
10mm/17mm Combination Open End Wrench
(supplied, see figure below)
1.5mm & 3mm Hex “L” Wrench
(supplied, see figure below)
Rear Cover Tool Storage
1
3
2
The Open End Wrench and Hex Wrenches are stored on the inside rear cover of the saw. To remove the cover, unscrew the two top and center thumb screws.
Thumb
Screws
Combination Square Must be True
1.Use the straight edge of a 3/4" thick board (this edge must be perfectly straight).
2.Draw a line on the board along this edge.
3.There should be no gap or overlap when the square is flipped over in dotted position.
10.
